DOWNLOAD Panasonic KX-TS2382RUB / KX-TS2382RUW Service Manual ↓ Size: 1.99 MB | Pages: 29 in PDF or view online for FREE

13

14

Even if you do not have the special tools (for example, a spot heater) to remove the Flat IC, with some solder (large amount), a
soldering iron and a cutter knife, you can easily remove the ICs that have more than 100 pins.

• PbF (: Pb free) Solder
• Soldering Iron

Tip Temperature of 700

°F ± 20°F (370°C ± 10°C)

Note: We recommend a 30 to 40 Watt soldering iron. An expert may be able to use a 60 to 80 Watt iron where someone with
less experience could overheat and damage the PCB foil.

• Flux

Recommended Flux: Specific Gravity 

→ 0.82.

Type 

→ RMA (lower residue, non-cleaning type)

Note: See About Lead Free Solder (Pbf: Pb free) (P.4).

1. Put plenty of solder on the IC pins so that the pins can be completely covered.

If the IC pins are not soldered enough, you may give pressure to the P.C. board when cutting the pins with a cutter.

2. Make a few cuts into the joint (between the IC and its pins) first and then cut off the pins thoroughly.

3. While the solder melts, remove it together with the IC pins.

When you attach a new IC to the board, remove all solder left on the land with some tools like a soldering wire. If some solder is left
at the joint on the board, the new IC will not be attached properly.

15

1. Temporarily fix the FLAT PACKAGE IC, soldering the two marked pins.

*Check the accuracy of the IC setting with the corresponding soldering foil.

2. Apply flux to all pins of the FLAT PACKAGE IC.

3. Solder the pins, sliding the soldering iron in the direction of the arrow.

1. Lightly resolder the bridged portion.
2. Remove the remaining solder along the pins using a soldering iron as shown in the figure below.

16