Panasonic KX-TG1411RUM / KX-TG1411RUT / KX-TG1412RU1 / KX-TGA141RUM / KX-TGA141RUT Service Manual ▷ View online
41
KX-TG1411RUM/KX-TG1411RUT/KX-TG1412RU1/KX-TGA141RUM/KX-TGA141RUT
11.8. RF Specification
11.8.1. Base Unit
*: Refer to Check Point (Base Unit) (P.24)
11.8.2. Handset
**: Refer to Check Point (Handset) (P.27)
Item
Value
Refer to -. *
TX Power
More than 14 dBm ~ 26 dBm
Check Point (Base Unit) (H)
Modulation
340 kHz/div ~ 402 kHz/div
Check Point (Base Unit) (I)
Frequency Offset
-50 kHz ~ +50 kHz
Check Point (Base Unit) (J)
RX Sensitivity
< 1000 ppm
Check Point (Base Unit) (K)
Timing Accuracy
< ± 2.0 ppm
Check Point (Base Unit) (L)
RSSI Level
0E hex ± A hex
Check Point (Base Unit) (M)
Item
Value
Refer to -. **
TX Power
More than 19 dBm ~ 25 dBm
Check Point (Handset) (I)
Modulation
340 kHz/div ~ 402 kHz/div
Check Point (Handset) (J)
Frequency Offset
-50 kHz ~ +50 kHz
Check Point (Handset) (K)
RX Sensitivity
< 1000 ppm
Check Point (Handset) (L)
Timing Accuracy
< ± 2.0 ppm
Check Point (Handset) (M)
RSSI Level
0E hex ± 5 hex
Check Point (Handset) (N)
42
KX-TG1411RUM/KX-TG1411RUT/KX-TG1412RU1/KX-TGA141RUM/KX-TGA141RUT
11.9. How to Check the Handset Speaker or Receiver
1. Prepare the digital voltmeter, and set the selector knob to ohm meter.
2. Put the probes at the speaker terminals as shown below.
2. Put the probes at the speaker terminals as shown below.
11.10. Frequency Table (MHz)
Note:
Channel No. 10: In the Test Mode on Base Unit and Handset.
BASE UNIT
HANDSET
Channel No
Transmit Frequency
Receive Frequency
Transmit Frequency
Receive Frequency
1
1928.448 1928.448 1928.448 1928.448
2
1926.720
1926.720
1926.720
1926.720
3
1924.992 1924.992 1924.992 1924.992
4
1923.264 1923.264 1923.264 1923.264
5
1921.536
1921.536
1921.536
1921.536
6
1919.808 1919.808 1919.808 1919.808
7
1918.080
1918.080
1918.080
1918.080
8
1916.352
1916.352
1916.352
1916.352
9
1914.624 1914.624 1914.624 1914.624
10
1912.896 1912.896 1912.896
1912.896
43
KX-TG1411RUM/KX-TG1411RUT/KX-TG1412RU1/KX-TGA141RUM/KX-TGA141RUT
12 Miscellaneous
12.1. Terminal Guide of the ICs, Transistors and Diodes
12.1.1. Base Unit
12.1.2. Handset
44
KX-TG1411RUM/KX-TG1411RUT/KX-TG1412RU1/KX-TGA141RUM/KX-TGA141RUT
13 Schematic Diagram
13.1. For Schematic Diagram
13.1.1. Base Unit (Schematic Diagram (Base Unit))
Notes:
1. DC voltage measurements are taken with voltmeter from the negative voltage line.
2. This schematic diagram may be modified at any time with the development of new technology.
13.1.2. Handset (Schematic Diagram (Handset))
Notes:
1. DC voltage measurements are taken with an oscilloscope or a tester with a ground.
2. The schematic diagrams may be modified at any time with the development of new technology.
2. The schematic diagrams may be modified at any time with the development of new technology.
13.1.3. Charger Unit (Schematic Diagram (Charger Unit))
Notes:
1. DC voltage measurements are taken with voltmeter from the negative voltage line.
2. This schematic diagram may be modified at any time with the development of new technology.
Click on the first or last page to see other KX-TG1411RUM / KX-TG1411RUT / KX-TG1412RU1 / KX-TGA141RUM / KX-TGA141RUT service manuals if exist.