DOWNLOAD Panasonic KX-TCD951GB / KX-TCD955GC Service Manual ↓ Size: 2.22 MB | Pages: 78 in PDF or view online for FREE

6

Install the batteries as shown. Then install the handset cover.

•

 If the rechargeable batteries are not inserted correctly, the handset will not work.

Plug in the AC adaptor and the telephone line cord to the bottom of the unit. Then connect the cords as shown.

• USE ONLY WITH Panasonic AC ADAPTOR KX-TCA11CE.

• Be careful not to confuse the telephone line jack with the AC adaptor jack on the base unit. If connected improperly, the base

unit will not work and damage may occur.

• The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)

• This telephone has a single terminal which must be connected to an analog telephone line with a TAE-F connector.

• The telephone will not work during a power failure. We therefore recommend you use a standard telephone and automatic

change-over switch to connect this Digital Cordless Phone to the line.

Your Panasonic sales shop can offer you more information about connection possibilities.

• If your unit is connected to a PBX which does not support Caller ID services, you cannot access those services.

(KX-TCD955GC only.)

Fig. 10

Fig. 11

N F

Fasten the cords to prevent them 
from being disconnected.

Hooks

To Power Outlet
(AC 230 V, 50 Hz)

To Single-Line
Telephone Jack

AC Adaptor

Telephone Line Cord

Telephone
Line Cord

AC 
Adaptor

8

You can hang the handset on your belt or pocket using the belt clip.

You can program the dialling mode to tone or pulse. If you have touch tone service, set to tone. If rotary or pulse service is
used, set to pulse. The factory preset is tone.
Make sure that the power is ON and the unit is in the stand-by mode.

Fig. 14

Fig. 15

1

  Press 

 then 

.

2

  Press 

3

  Enter the base unit password.

• The factory preset is 0000. To change the base unit

password.

4

  Press 

• The current mode is displayed.
1:Tone             2:Pulse
Ex. Tone is selected.

5

  To select Pulse, press

 .

6

  Press 

 .

• A confirmation tone sounds and the display will return to

the stand-by mode.

• If 5 beeps sound in step 3, the entered password is

incorrect. Enter the correct password.

• To cancel during programming, press 

, then start from

step 1.