Panasonic KX-TC1045RUB Service Manual ▷ View online
1 STANDARD BATTERY LIFE
3
2 LOCATION OF CONTROLS
4
3 CONNECTION TO A TELEPHONE LINE
6
4 OPERATIONS
7
5 DISASSEMBLY INSTRUCTIONS
10
6 ADJUSTMENTS (BASE UNIT)
12
7 ADJUSTMENTS (HANDSET)
13
8 CPU DATA (Base Unit)
16
9 CPU DATA (Handset)
17
10 EXPLANATION OF CPU DATA COMMUNICATION
18
11 FREQUENCY TABLE (MHz)
24
12 HOW TO REPLACE FLAT PACKAGE IC
25
13 TERMINAL GUIDE OF ICS, TRANSISTORS AND DIODES 26
14 FOR SCHEMATIC DIAGRAM
14 FOR SCHEMATIC DIAGRAM
27
15 CIRCUIT BOARD RF UNIT (Base Unit)
27
16 SCHEMATIC DIAGRAM RF (Base Unit)
29
17 CIRCUIT BOARD MAIN (Base Unit)
31
18 SCHEMATIC DIAGRAM
33
19 CIRCUIT BOARD (Handset)
35
20 BLOCK DIAGRAM (BASE UNIT)
37
21 NEW CIRCUIT OPERATION (BASE UNIT)
38
22 NORMAL CIRCUIT OPERATION (BASE UNIT)
38
23 BLOCK DIAGRAM (HANDSET)
45
24 NEW CIRCUIT OPERATION (HANDSET)
46
25 NORMAL CIRCUIT OPERATION (HANDSET)
50
26 TROUBLESHOOTING GUIDE (BASE UNIT)
51
27 TROUBLESHOOTING GUIDE (HANDSET)
54
28 CABINET AND ELECTRICAL PARTS (Base Unit)
56
29 CABINET AND ELECTRICAL PARTS (Handset)
57
30 ACCESSORIES AND PACKING MATERIALS
58
31 REPLACEMENT PARTS LIST
59
CONTENTS
Page
Page
2
KX-TC1045RUB
1 STANDARD BATTERY LIFE
After your Panasonic battery is fully charged;
While in use (TALK)
Up to about 8 hours
While not in use (Stand-By)
Up to about 30 days
•
•
Battery life may vary depending on usage conditions and ambient temperature.
•
•
Clean the handset and the base unit charge contacts with a soft, dry cloth. Clean if the unit is subject to grease, dust
or high humidity. Otherwise the battery may not charge properly.
or high humidity. Otherwise the battery may not charge properly.
•
•
If the battery is fully charged, you do not have to place the handset on the base unit until the RECHARGE indicator flashes. This
will maximize the battery life.
will maximize the battery life.
•
•
The battery cannot be overcharged.
3
KX-TC1045RUB
2 LOCATION OF CONTROLS
4
KX-TC1045RUB
2.1. Base Unit Display
The clock needs adjusting.
Your greeting message was not recorded
correctly. Record it again.
correctly. Record it again.
The unit is in the answering system programming
mode.
mode.
The speaker volume level is set to "5".
You can select 9 levels (0-8) while using the
answering system.
You can select 9 levels (0-8) while using the
answering system.
12 messages have been recorded.
FULL
Memory is full. Erase some, or all, of the
messages.
messages.
The recording time is set to "greeting only".
(The display is blank.)
(The display is blank.)
PAGER
The pager call mode is set to ON.
5
KX-TC1045RUB
