Panasonic AG-MX70E / AG-MX70MC / AG-YA70P / AG-VE70P Service Manual ▷ View online
INF-8
4. The way of attaching an option board
4-1. Installation of the AG-YA70P
The AG-YA70P is an interface board that enables the AG-MX70 to be connected to a serial digital interface (SDI).
Follow the procedure below to install it.
Follow the procedure below to install it.
1. Turn off the power of the AG-MX70 and remove the ten screws from the bottom panel.
2. Remove the six screws from the rear panel, then remove the blank panel.
3. Open the top unit, including the LCD, from the front, then release the bands securing the flexible cable and
blue cable of the unit.
4. Fix the unit perfectly upright so it does not topple. When removing the casing, ensure the flexible and other
cables do not become detached.
Screws (10 pcs)
Blank panel
Screws (6 pcs)
INF-9
5.
Remove the twenty screws from the shield casing, then remove the casing itself.
6.
Remove the two hexagonal screws for anchoring the AG-YA70P to the motherboard.
7.
Insert the AG-YA70P board. (Refer to the figure at left.)
Screws
(20 pcs)
(20 pcs)
Fixing screws
for AG-YA70P
for AG-YA70P
Fixing screws
for AG-VE70P
for AG-VE70P
INF-10
8.
Insert the cable from the AG-YA70P into the connector on the motherboard. (Refer to the figure at left.)
9.
Secure the two screws which were removed in step 6.
10. Secure the shield casing and the twenty screws which were removed in step 5.
11. Re-attach the bands removed in step 3. and close the top unit.
12. Secure the six screws which were removed in step 2.
13. Secure the ten screws which were removed in step 1.
4-2. Installation of the AG-VE70P
The AG-VE70P is a 3D effect board that enables the 3D patterns, etc. of the AG-MX70 to be used.
Follow the procedure below to install it.
Follow the procedure below to install it.
1. Turn off the power of the AG-MX70 and remove the ten screws from the bottom panel.
Screws (10 pcs)
INF-11
2. Open the unit in the top part including the LCD out toward the front, then release the bands securing the
flexible cable and blue cable of the unit.
3. Fix the unit perfectly upright so it does not topple.
When removing the casing, ensure the flexible and other cables do not become detached.
4.
Remove the twenty screws from the shield casing, then remove the casing itself.
5.
Remove the five hexagonal screws for anchoring the AG-VE70P to the motherboard.
Screws
(20 pcs)
(20 pcs)
Fixing screws
for AG-YA70P
for AG-YA70P
Fixing screws
for AG-VE70P
for AG-VE70P
Click on the first or last page to see other AG-MX70E / AG-MX70MC / AG-YA70P / AG-VE70P service manuals if exist.