Panasonic TH-50PF11EK Service Manual ▷ View online
16
TH-50PF11EK
7.1.2.
Power LED Blinking timing chart
1. Subject
Information of LED Blinking timing chart.
2. Contents
When an abnormality has occurred to the unit, the protection circuit operates and resets to the stand by mode. At this time,
the defective block can be identified by the number of blinks of the Power LED on the front panel of the unit.
the defective block can be identified by the number of blinks of the Power LED on the front panel of the unit.
About blinking LED
17
TH-50PF11EK
7.2.
No Power
First check point
There are following 3 states of No Power indication by power LED.
There are following 3 states of No Power indication by power LED.
1. No lit.
2. Green is lit then turns red blinking a few seconds later.
3. Only red is lit.
2. Green is lit then turns red blinking a few seconds later.
3. Only red is lit.
7.3.
No Picture
18
TH-50PF11EK
7.4.
Local screen failure
Plasma display may have local area failure on the screen. Fig - 1 is the possible defect P.C.B. for each local area.
Fig - 1
19
TH-50PF11EK
8 Disassembly and Assem-
bly Instructions
• To disassemble P.C.B., wait for 1 minute after power was off
for discharge from electrolysis capacitors.
•
, ,
, and marks indicate screw positions.
8.1.
Removal of Rear Cover
1. Remove screws (
×8 ,
×28 ,
×4 ) and then remove
the Rear Cover.
8.2.
Removal of HA-Board
1. Remove 4 screws (A) and then remove the HA Terminal
Block.
2. Remove 4 screws (B).
3. Remove 3 screws (C) and then remove HA-Board.
3. Remove 3 screws (C) and then remove HA-Board.
8.3.
Removal of HDE-Board
1. Remove 4 screws (D) and then remove the HDE Terminal
Block.
2. Remove 4 screws (E).
3. Remove the 2 Hexagonal-Head screws (F) and then
3. Remove the 2 Hexagonal-Head screws (F) and then
remove HDE-Board.
8.4.
Removal of Slot Block
1. Disconnect the connectors (DS2, DS4, DS6, DS7, DS8,
DS15).
2. Remove the flexible cables from the connectors (DS1,
DS3).
3. Remove 2 screws ( ).
4. Remove 4 screws ( ) and then remove the Slot Block.
4. Remove 4 screws ( ) and then remove the Slot Block.
Click on the first or last page to see other TH-50PF11EK service manuals if exist.