Panasonic KX-NT400RU Service Manual ▷ View online
13
KX-NT400RU
4.2.9.
Sub-CPU(IC4)
IC4 controls KEY, LED.
A reset signal from the VoIP(IC1) starts either reset or normal operating.(L:RESET)
The SUB-CPU and VoIP are connected by a serial communication.
A reset signal from the VoIP(IC1) starts either reset or normal operating.(L:RESET)
The SUB-CPU and VoIP are connected by a serial communication.
14
KX-NT400RU
4.2.10. KEY Input Control Circuit
The key data is under the matrix control by IC4.
The key information outputted from KEYOUT is inputted into KEYIN, when the key is pressed.
The HOOK key is independent from Key Scan Matrix and taken into the port singularly.
The key information outputted from KEYOUT is inputted into KEYIN, when the key is pressed.
The HOOK key is independent from Key Scan Matrix and taken into the port singularly.
15
KX-NT400RU
KEY INPUT CONTROL TIMING CHART
4.2.11. LED Circuit
The lighting of the LED is controlled by IC4.
The LED lights up in a dynamic lighting system.
The duty ratio is 1/8(ON time 1.5ms).
The LED lights up in a dynamic lighting system.
The duty ratio is 1/8(ON time 1.5ms).
16
KX-NT400RU
LED DYNAMIC LIGHTING
4.2.12. Power Supply Circuit
This Power Supply Circuit supports the power supply through an Ethernet line called PoE(Power over Ethernet) as well as the
input from a regular AC adapter.
input from a regular AC adapter.
The power supply is as follows;
Click on the first or last page to see other KX-NT400RU service manuals if exist.