Panasonic KX-HDV100RU / KX-HDV100RUB Service Manual ▷ View online
29
KX-HDV100RU/KX-HDV100RUB
4. Remove the Flat Cable and remove the LCD Assy.
5. Remove Lead Wires with the soldering iron.
5. Remove Lead Wires with the soldering iron.
6. Remove 3 Screws (A) and remove the Main Board.
Flat Cable
Lead Wire
LCD Assy
Main Board
(A)
(A)
(A)
30
KX-HDV100RU/KX-HDV100RUB
10.2. Remove LCD
1. Push the Tabs and remove the LCD Panel from the LCD Holder.
2. Push the Tabs and remove the LCD.
LCD Holder
LCD Pane
Tab
Tab
Tab
LCD
31
KX-HDV100RU/KX-HDV100RUB
10.3. Assembly for Lead wire
Perform this process in reverse when taking the unit apart.
10.3.1.
Connecting Lead Wires
Blue
Blue
Blue
Purple
Purple
Gray
Gray
Orange
Orange
Orange
Solder
Solder
Solder
Solder
Solder
Solder
Solder
Black Red
Yellow
Brown
Fully insert the FFC into the
connector until the edge of
the reinforcing plate is
aligned with the edge of the
Main Board.
connector until the edge of
the reinforcing plate is
aligned with the edge of the
Main Board.
Cable is to be inserted into connector
(CN504) and (CN101) without any inclining,
as shown.
<NG>
<OK>
Note:
32
KX-HDV100RU/KX-HDV100RUB
10.3.2.
Clamping Lead Wires
Clamp
Clamp
Clamp
Clamp
Clamp
1
2
No clamp LEAD WIRE to each slot as follows at bottom PCB.
- No 1 : Wire from Handset Jack (Black & Brown)
- No 2 : Wire from Handset Jack (Red & Yellow)
- No 1 : Wire from Handset Jack (Black & Brown)
- No 2 : Wire from Handset Jack (Red & Yellow)
Handset Jack
Clamp
Tape
Click on the first or last page to see other KX-HDV100RU / KX-HDV100RUB service manuals if exist.