DOWNLOAD Panasonic UB-T781 / UB-T781W / UB-T761 Service Manual ↓ Size: 3.11 MB | Pages: 115 in PDF or view online for FREE

53

5. Remove the 2 wing bolts to release the elite Panaboard from the stand (Figure-A).
6. Remove the 6 screws (H).
7. Remove the pen tray cover-front with a pen tray.
8. Remove the 3 screws (I) and pen tray cover-back.

54

9. Open the pen tray as shown in the Figure-1, and move the pen tray in the direction of the arrow (2). (Figure-2)

10. Remove the 3 screws (J), then separate the pen tray-outer from the pen tray-inner. (Figure-3)

55

Before performing the following steps, remove the following parts.

• Front Lower Frame Cover, Control-Power Cover-Front and Hub PCB Shield Plate (refer to the section 6.2 “Power, Hub and Con-

trol Boards”).

• Side Cover L (refer to the section 6.4.2.1 “Side Cover L, Upper Frame Cover and Side Cover R”).

1. Remove the screw (A) and ground harness.
2. Disconnect the inlet harness.
3. Release the ground harness and inlet harness from the clamper.
4. Remove the 2 screws (B), ground harness and AC switch unit.

5. Remove the 2 wing bolts to release the elite Panaboard from the stand.
6. Remove the 3 screws (C) and control-power cover-back.
7. Remove the 3 screws (D) and AC inlet assembly

56

1.

Remove the battery cover.

2.

Remove the battery.

3.

Remove the screw.

4.

Separate the cover from the base cover while pushing the base cover as shown in the following figure.

5.

Remove the penpoint from the penpoint shaft.

6.

Remove the film cover and penpoint shaft.