DOWNLOAD Panasonic EP-MA73 / EP-MA73KU892 Service Manual ↓ Size: 6.91 MB | Pages: 88 in PDF or view online for FREE

53

15. Remove Magic Tapes, and cut two Cable ties.

16. Remove four Hoses, one Connector, and the Multiaction

spring, and remove the Foot cloth.

17. Remove the Shiatsu sheets.

• Be careful of the directions when in assembly.

18. Insert a screwdriver putting between the Foot air bags

and the Foot cover, and remove six screws, which fix the
Foot heater.

19. Remove two Anchor clips each on right/left sides on back,

which fix the Foot air bags.

20. Remove the Foot heater.

• Work would be easy in assembly if the Foot heater is

inserted from the back.

54

21. Remove two Anchor clips each on right/left sides in the

front, which fix the Foot air bags, and remove the Foot air
bags.
Caution

• Be careful of the install of the Air bags when in assembly.

22. Remove two screws, which install the Slide stopper, and

remove the right/left Slide spring cover.
Caution

• Hook the Hook first, and tighten screws when in assem-

bly.

23. Remove the right/left Slide pulling srings.
24. Slide the frame so that the screws on the rail are visible,

and remove four screws each on right/left sides and cut
Cable ties. Then remove three Hoses and one Connector.

25. Pull out the tip of the zippers of the Leg cloth from inside

and cut the Cable tie, and open the zippers. And remove
the Foot cloth.

55

• When in assembly, put the plate of the Cloth between the

Frame and the Leg cover.

26. Remove eight Hoses and eight Anchor clips, and remove

the Air bags.

1. Proceed all the procedures of 9.6. Removing the Rear

cover.

2. Push the Lower button of the Controller, and move the

Massage mechanism block to the lowest position.

3. Remove four screws, and remove the Massage block

cover.

4. Remove the Fixing screw for the Connecting cord for

power source and the Ground wire, and remove three
Connectors.

5. Cut the Cable tie T30R, and remove the Connecting cord

for power source from the Massage block cover clip.

6. Remove four screws each on right/left sides, and remove

Rail piece sets (right/left sides).

56

Hold the Massage mechanism block by hand not to have it
fall down.

Be careful of the directions of the Rail piece set left/right.

Be sure to handle the Massage mechanism block carefully
so that the PCB of the Pressure sensor is not pushed to the
desk or given extra pressure when putting the Massage
mechanism block, which could lead to the crack of the PCB.
This may eventually cause the malfunction such as “The
Body pressure levels on the Controller does not increase.”
“It does not scan,” or “The operation is not stable.” etc.