Panasonic NR-C45H1 / NR-D53H1 / NR-55D1 / NR-700D / NR-700M / NR-700MS / NR-700R Service Manual ▷ View online
---- 9 ----
C45H1, D53H1, D55D1,
D700D, D700M,
D700MS, D700R
D700D, D700M,
D700MS, D700R
SECTION III SCHEMATIC DIAGRAMS
WIRING CONNECTION DIAGRAM (NR-C45H1)
SCHEMATIC DIAGRAM (NR-C45H1)
---- 10 ----
C45H1, D53H1, D55D1,
D700D, D700M,
D700MS, D700R
D700D, D700M,
D700MS, D700R
SECTION III SCHEMATIC DIAGRAMS
WIRING CONNECTION DIAGRAM (NR-D53H1, D700R)
SCHEMATIC DIAGRAM (NR-D53H1, D700R)
---- 11 ----
C45H1, D53H1, D55D1,
D700D, D700M,
D700MS, D700R
D700D, D700M,
D700MS, D700R
SECTION IV DISASSEMBLY INSTRUCTION
THERMOSTAT
BIMETAL THERMO., THERMAL FUSE,
DC FAN MOTOR AND DEFROST HEATER
Take out the FC bottom case & top case.
Remove the screws (1 pcs) which fix the control box.
Pull the control box.
Remove the screws (1 pcs) which fix the control box.
Pull the control box.
NOTE:
Thermo. dial can not be removed by pulling it toward you.
Take out the PC shelf & bottom plate PC.
Take out the VC bottom case & top case.
Remove the screw (3 pcs) which fix the control panel.
Pull the control panel.
Pull the top portion of cover coil & fan motor as.
Take out the VC bottom case & top case.
Remove the screw (3 pcs) which fix the control panel.
Pull the control panel.
Pull the top portion of cover coil & fan motor as.
Pull the control box toward you to remove.
Disconnect the terminals (2pcs.).
Disconnect the terminals (2pcs.).
Unhook thermo. Capillary.
RUnhook thermostat.
RUnhook thermostat.
Then thermostat and thermo. dial can be removed.
CAUTION
To replace the thermostat
Thermo. capillary should be hooked in plate.
Each part is installed as shown in the figure.
(BIMETAL THERMO., AND THERMAL FUSE)
Pull the bimetal thermo. to the direction of arrow.
Cut binding tube and remove thermal fuse.
Cut binding tube and remove thermal fuse.
To replace bimetal thermostat
Be sure to set bimetal thermostat so that heat sensor.
(Orange wire should be lower.)
Cover coil &
Fan Motor
AS.
Terminal
Binding
tube
tube
Binding
tube
tube
Thermo. capillary
Hook for
thermo. capillary
thermo. capillary
Hook for
thermostat
thermostat
Thermostat
Thermo.
dial
Bimetal thermo.
Thermal
fuse
fuse
@@@@@@@@e?
@@@@@@@@e?
@@h?
@@h?
@@h
?
@@h?
@@h?
@@h?
@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e
@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?
@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@
@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?
@@@@@@@@
@@@@@@@@
@@
@@
@@
@@
@@
@@
@@
@@
@@
@@
@@
@@
@@
@@
?@@
?@@
?@@
?@@
?@@
?@@
?@@@@@
@@@
?@@@@@@@@
?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@
@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e
?@@@@@@@@?e@@@@@@@@e?@@@@@@@@
?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@
@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@
@@g
@@g
@@g
@@g
@@g
@@g
@@@@@@@@
@@@@@@@@
@@
@@
@@
@@
@@
@@
@@
@@
Screw
Defrost heater
Thermal fuse
Bimetal thermo.
---- 12 ----
C45H1, D53H1, D55D1,
D700D, D700M,
D700MS, D700R
D700D, D700M,
D700MS, D700R
To replace thermal fuse
Be sure to put thermal fuse in place.
Bind lead wire without loose as shwn in the figure.
Bind lead wire without loose as shwn in the figure.
(DCFAN MOTOR)
Disconnect the terminals (1 pcs).
Remove the crape tape which set the ins. cover coil & DC
Remove the crape tape which set the ins. cover coil & DC
fan motor.
(DEFROST HEATER)
Remove the cover coil & fan motor as.
Lifting the evaporator at right gradually, pull it toward you.
Lifting the evaporator at right gradually, pull it toward you.
NOTE:
Special care should be taken not to twist and break the pipe.
To replace the DC fan motor
Insert the DC fan motor case into the ins. cover coil back.
Connect the terminal.
Connect the terminal.
Heater holder is hooked to the evaporator pipe.
Disconnect the connector of heater lead wire.
Lift the edge of heater and make it straight.
Then pull the heater holder as shown in the figure.
To replace the defrost heater
Insert the heater into the heater holder properly.
Hook the heater holder to the evaporator pipe.
Arrange the lead wire of heater by using hook for lead wire
Hook the heater holder to the evaporator pipe.
Arrange the lead wire of heater by using hook for lead wire
so that it will not loose.
Evaporator
Suction pipe
Crape tape
Ins. cover coil
Connector
DC Fan motor
Eva. holder
Evaporator
Lead wire
Heater holder
Heater holder
Edge
Heater cover
Defrost
heater
heater
Hook
for lead wire
for lead wire
Heater cover
Defrost heater
Click on the first or last page to see other NR-C45H1 / NR-D53H1 / NR-55D1 / NR-700D / NR-700M / NR-700MS / NR-700R service manuals if exist.