Panasonic NR-BL267 / NR-BL307 / NR-BL347 Service Manual ▷ View online
6.2.3. Door switch
1. Push to the left then pull out
DOOR SWITCH
.
2. Pull down the door switch lightly,
then undo connector.
then undo connector.
6.3. Machine room
6.3.1. PCB, Supply cord & harness as wire main, MF capacitor, Relay, Motor protector
1. Remove the
PAN WATER EVA
2. Unscrew
3 screws.
3.
Unscrew to open the BOX PCB.
4. Disconnect
5 connectors.
5. Push on t
he clamp to take out PAS-BL267 (MAIN).
6. Remove the
COVER PROTECTOR. Pull out the MOTOR
PROTECTOR-INV and the connector from COMPRESSOR.
7. Undo two claims with
7. Undo two claims with
HARNESS AS WIRE (CM) to
take out M
OTOR PROTECTOR-INV
connector
BOX PCB
P
AN WATER EVA
COVER PROTECTOR
screw
MOTOR PROTECTOR- INV
Connector
MOTOR PROTECTOR-INV
HARNESS AS. WIRE (CM)
clamp
P
AS-BL267 (MAIN)
connectors
screw
2
1
3
6
5
4
13
6.4. Replace FC, PC door
6.4.1. Replace FC door
Disassembly FC door
1.
Open the FC door then remove COVER HINGE TOP:
- Push up follow direction
1.
2. Unscrew 3 screws, then lift up the FC door.
Assembly FC door
1. Apply grease to the areas of No. 1& No. 2 of
HINGE CENTER.
2. Put FC door : pin of
HINGE CENTER fit to the hole of latch door.
3. Assembly hinge top: screw follow the order No.1, 2,
3.
1. Use Torque driver to check force at screw 1, 2, 3 position. Standard is 600± 200cN.m.
Then assembly
Then assembly
COVER HINGE TOP.
2. Deviation between FC door and side of cabinet is a≤1mm.
3. Apply grease to the line of
3. Apply grease to the line of
GASKET DOOR FC as figure to avoide the twist of the gasket
a
COVER HINGE TOP
HINGE CENTER
1
2
screw
s
2
3
1
position applied
screw
s
1
6.4.2. Replace PC door
Disassembly PC door: FC door must be disassembly before the disassembly of the PC door.
- Unscrew No. 1, 2, 3 of
HINGE CENTER.
- Lift up the PC door.
Assembly PC door
1. Apply grease to the areas No. 1 & No. 2 of the
HINGE BOTTOM
2. Put PC
DOOR fit with HINGE BOTTOM.
3. Apply grease to the showed line of
GASKET DOOR FC as figure to avoid the twist of the gasket door.
4. Screw of
HINGE CENTER and check force at screw 1 and 2. Standard is 600± 200cN.m
1
hinge bottom
2
hinge bottom
1
2
apply position
600 ± 200cN.m
screw
s
1
2
3
15
16
7.1 Part exploded view: Body
7. Part exploded view and replacement part list
Click on the first or last page to see other NR-BL267 / NR-BL307 / NR-BL347 service manuals if exist.