Panasonic MC-E601 / MC-E603 Service Manual ▷ View online
2 SCHEMATIC DIAGRAM
MODELS MC-E601 / MC-E603
3
MC-E601 / MC-E603
3 REPARE OF MAIN PARTS
1. Lift up the handle and remove 2 screws from the control
panel. (Fig.1)
Fig.1
2. Open the dust cover and release (with a flat head
screwdriver) the control panel fastening points and remove
control panel. (Fig. 2)
control panel. (Fig. 2)
Fig.2
3. Remove exhaust cover, rear cover and 5 screws from upper
body and pull to take it out. (Fig. 3)Note: To remove the
exhaust cover pry out with a flat head screwdriver as shown
in the illustration.
exhaust cover pry out with a flat head screwdriver as shown
in the illustration.
Fig.3
4. Take out cord reel ass´y and remove the lead wires
(provided with quick-connect terminal) from the contact
spring tabs. (Fig. 4)
spring tabs. (Fig. 4)
IMPORTANT NOTE: Before replacing any part always, DISCONNECT THE CLEANER FROM THE ELECTRICITY SUPPLY.
3.1.
MOTOR
4
MC-E601 / MC-E603
Fig.4
5. Take out motor unit and remove 2 crews to take out motor
cover. (Fig. 5)
Fig.5
6. Disconnect the lead wires (provided with quick-connect
terminals) from the carbon brush holder tabs and remove
front motor support. (Fig. 6)
front motor support. (Fig. 6)
7. Replace the motor with a new one and connect the lead
wires to the carbon brush holder tabs.
Fig.6
8. Reassemble front motor support and motor cover. Then
refasten the two screws. (Fig. 7)
Note
Make sure the lead wires are correctly positioned to
avoid pinching them between parts.
avoid pinching them between parts.
Fig.7
9. Place the motor unit and cord reel ass´y into the lower
body.Note: Align rear motor support with the lower body
guides. (Fig. 8)
guides. (Fig. 8)
10. Connect the lead wires according to the schematic diagram
and reassemble the remaining parts in the reverse order.
Note
Before reassembling upper body and exhaust cover
introduce the cord plug through their holes.
introduce the cord plug through their holes.
5
MC-E601 / MC-E603
Fig.8
Note
The two carbon brushes should be replaced at the same
time.
time.
1. Take out motor unit and remove motor cover as explained
previously in paragraph 3.1 Motor, points 1-5.
2. Disconnect
lead
wires
(provided
with
quick-connect
terminal) from the carbon brush holder tabs.
3. Remove the screw from the carbon brush holder to take it
out. (Fig. 9)
4. Replace carbon brush unit with a new one.
fig.9
5. Insert the new carbon brush unit into the motor housing and
refasten the screw. (Fig. 10)
6. Connect the lead wires to the motor tabs and reassemble
motor unit.
7. Connect the lead wires to the motor tabs and reassemble
motor unit.
fig.10
3.2.
CARBON BRUSHES
6
MC-E601 / MC-E603