DOWNLOAD Panasonic ES-SL41A520 / ES-SL41R520 / ES-SL41S520 Service Manual ↓ Size: 452.77 KB | Pages: 14 in PDF or view online for FREE

5

6. Insert the something like a slotted screwdriver into the

internal left side of the trimmer assembly as the figure.
NOTE:

Confirm the location.  If the screwdriver is inserted
right side, the trimmer hooks may be broken.

7. Remove the trimmer assembly from the left side.

8. Push down the cleaning shutter lever.

6

9. Insert the something like a slotted screwdriver into the right side of the cleaning shutter cover.  Remove it from the upper side.

There are three hooks, top, right and left side.

If the screwdriver is inserted into the left side, the hooks may be broken or caused any scratch.

10. Insert the something like a slotted screwdriver into the right side of the front panel to raise it up as the figure.

And then, insert a slotted screwdriver into the left side of the front panel and remove it from the left side.
NOTE:

There are seven hooks on top, right and left side.  If the screwdriver is inserted into the left side first, the hooks may be
broken.

11. Loosen four screws from housing A.

12. Loosen four screws from housing B.  And remove the housing B.

7

13. Slide the module and battery assembly to slant upward.

14. Remove the battery with o-ring and washer from the

chassis.

15. Remove the trimmer driving bar or the slit blade driving

bar with pressing bars outward.

16. Loosen two screws on top and remove retaining plate.

17. Remove waterproof rubber and two driving heads.

18. Loosen a screw on top.  Fit the shape of motor balancer

and the hole of housing A and take out the motor from
housing A.

8

When reassembling, replace the new waterproof rubber.
Make sure whether there is NO foreign substance sticking 
around a part covered with the water seal.

Make sure to assemble the battery last in order to avoid
short-circuited.

Place the red mark on upper side.  Fit the shape of motor bal-
ancer and the hole of housing A and insert into housing A.

Insert a tip pin of driving head 'B' into the hole of motor arm.
And fit the projections of housing into the hole of driving head
B.
Place a motor tip pin toward you.  Insert a motor tip pin into the
hole of driving head 'A' and fit the projections of housing into
the hole of driving head A.

The waterproof rubber must be fitted the right way around.
Install as shown in figure by inserting firmly to the set position.

Set the trimmer driving bar and the slit blade driving bar.