Panasonic ER-GS60-S520 Service Manual ▷ View online
5
For reassembling;
Spring for cutter has its own direction.
NOTE:
Spring for cutter has its own direction.
NOTE:
Do not lose the springs for cutter.
5. Loosen seven screws.
6. Loosen two screws on the rear side.
7. Separate the housing B from the housing A.
6
8. Pull the chassis upward.
9. Remove the battery from the chassis.
NOTE:
The battery has its own direction for reassemble.
Make sure of their pole.
Make sure of their pole.
10. Unsolder the side terminals for their replacement.
NOTE:
When replacing the side terminals, press fit the lead
wires inside of housing B side properly.
wires inside of housing B side properly.
11. Loosen two screws and o-rings. Unsolder the lead wires
to remove the motor.
7
12. Pull the motor holder upward and take out the motor from
the motor holder.
8
5 Cautions in Assembly
NOTE:
When reassembling, replace the new waterproof rubber. Make sure whether there is NO foreign substance sticking around a
part covered with water seal.
part covered with water seal.
NOTE:
Make sure to assemble the battery last in order to avoid short-circuit.
5.1.
Waterproof rubber
The waterproof rubber must be fitted the right way around.
Install as shown in figure by inserting firmly to the set position.
NOTE:
Install as shown in figure by inserting firmly to the set position.
NOTE:
Waterproof rubber is supplied with housing B only.
5.2.
Rechargeable battery
Insert the rechargeable battery into chassis. Attach the battery
o-ring and washer to the battery.
NOTE:
o-ring and washer to the battery.
NOTE:
Make sure to assemble the battery last in order to avoid
short-circuit and their pole also.
short-circuit and their pole also.
Click on the first or last page to see other ER-GS60-S520 service manuals if exist.