Panasonic EH-NE84-K865 Service Manual ▷ View online
4. Disassembly and Assembly Instructions
4.1. Disassembly Instructions
1. Remove the FILTER FRAME ASSEMBLY
4. Remove TAPPING SCREWS by a cross
slot screw driver. Than take out AIR OUTLET RING
and AIR OUTLET GRILL by rotating follow the direction
below.
slot screw driver. Than take out AIR OUTLET RING
and AIR OUTLET GRILL by rotating follow the direction
below.
2. Remove three TAPPING SCREWS by a cross
slot screw driver,then Remove AIR INLET RING.
slot screw driver,then Remove AIR INLET RING.
5. Take off HOUSING AB follow the figure below.
3. Remove 2 TAPPING SCREWS at HOUSING A
by flat-blade screwdriver and 2 TORX SCREWS
at HANDLE by Driver then remove HANDLE AB.
by flat-blade screwdriver and 2 TORX SCREWS
at HANDLE by Driver then remove HANDLE AB.
6. Remove DISCHARGE COVER
Counter clockwise rotation
4. Disassembly and Assembly Instructions
4.1. Disassembly Instructions
7. Remove Ion Holder from DISCHARGE COVER as figure below.
8. Take off MOTOR HEATER ASSEMBLY, and PLATE SPRING from HOUSING B.
9. Remove PRINTED CIRCUIT ASSEMBLY from MOTOR HEATER ASSEMBLY
as figure below
as figure below
Unclip this 2 ribs
Unclip this 2 ribs
4.2 Assembly Instructions
1. Install PRINTED CIRCUIT ASSEMBLY into MOTOR HEATER ASSEMBLY as figure below.
Lead wire for PCB must be lock with ribs of MOTOR HEATER ASSEMBLY as below.
Lead wire lock on this ribs
(No control color)
2. Install MAIN SWITCH PLATE AB and MAIN SWITCH HOLDER.
3. Install Ion discharge in to DISCHARGE COVER.
Ribs of MAIN SWITCH
HOLDER must fully
lock with MAIN SWITCH
(2 Ribs)
HOLDER must fully
lock with MAIN SWITCH
(2 Ribs)
Click on the first or last page to see other EH-NE84-K865 service manuals if exist.