Panasonic KX-FP343UA Service Manual ▷ View online
6.6.7.3. NG EXAMPLE
105
KX-FP343UA
6.6.8. ANALOG BOARD SECTION
This chapter provides the testing procedures required for the analog parts. A signal route to be tested is determined depending
upon purposes. For example, the handset TX route begins at the handset microphone and the signal is output to the telephone
line. The signal mainly flowing on this route is analog. You can trace the signal with an oscilloscope. The signal flow on each
route is shown in the Check Sheet here. If you find a specific problem in the unit, for example if you cannot communicate with
the H/S, trace that signal route locally with the following Check Sheet and locate the faulty point.
upon purposes. For example, the handset TX route begins at the handset microphone and the signal is output to the telephone
line. The signal mainly flowing on this route is analog. You can trace the signal with an oscilloscope. The signal flow on each
route is shown in the Check Sheet here. If you find a specific problem in the unit, for example if you cannot communicate with
the H/S, trace that signal route locally with the following Check Sheet and locate the faulty point.
6.6.8.1. CHECK SHEET
Note:
{ }: Inside the digital board
106
KX-FP343UA
6.6.8.2. DEFECTIVE ITS (Integrated Telephone System) SECTION
1. No handset transmission / reception and no monitor reception
Perform a signal test in the ITS or the NCU section and locate a defective point (where the signal disappears) on each route
between the handset microphone and telephone line (sending), or between the telephone line and the handset speaker
(receiving), or between the microphone and the telephone line (sending), or between the telephone line and the speaker
(receiving). Check the components at that point. CHECK SHEET (P.106) is useful for this investigation.
between the handset microphone and telephone line (sending), or between the telephone line and the handset speaker
(receiving), or between the microphone and the telephone line (sending), or between the telephone line and the speaker
(receiving). Check the components at that point. CHECK SHEET (P.106) is useful for this investigation.
2. No pulse dialing
3. No ring tone (or No bell)
CROSS REFERENCE:
CHECK SHEET (P.106)
NCU SECTION (P.149)
107
KX-FP343UA
4. No tone dialing
CROSS REFERENCE:
CHECK SHEET (P.106)
6.6.8.3. DETECTIVE TAM INTERFACE SECTION
1. The FAX turns on, but does not arrive through TAM.
CROSS REFERENCE:
CIRCUIT OPERATION (P.156)
2. A FAX is received, but won´t switch from TAM to FAX.
CROSS REFERENCE:
ANALOG BOARD SECTION (P.106)
TAM INTERFACE SECTION (P.154)
108
KX-FP343UA
Click on the first or last page to see other KX-FP343UA service manuals if exist.