DOWNLOAD Panasonic KX-FC965RU Service Manual ↓ Size: 6.39 MB | Pages: 127 in PDF or view online for FREE

Model
KX-FC965RU
Pages
127
Size
6.39 MB
Type
PDF
Document
Service Manual
Brand
Device
Fax / THERMAL FAX WITH DECT
File
kx-fc965ru.pdf
Date

Panasonic KX-FC965RU Service Manual ▷ View online

9
KX-FC965RU-T
2.2.
Insulation Resistance Test
1. Unplug the power cord and short the two prongs of the plug with a jumper wire.
2. Turn on the power switch.
3. Measure the resistance value with an ohmmeter between the jumpered AC plug and each exposed metal cabinet part
(screw heads, control shafts, bottom frame, etc.).
Note: Some exposed parts may be isolated from the chassis by design. These will read infinity.
4. If the measurement is outside the specified limits, there is a possibility of a shock hazard.
2.3.
Battery Caution
CAUTION
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer’s Instructions.
The lithium battery is a critical component (type No. CR2032).  Please observe for the proper polarity and the exact location
when replacing it and the exact location when replacing it and soldering the replacement lithium battery in.
2.4.
Discarding of P. C. Board
When discarding P. C. Board, delete all personal information such as telephone directory and caller list or scrap P. C. Board.
10
KX-FC965RU-T
3 Specifications
3.1.
Base Unit
1
 Transmission speed depends upon the contents of the pages, resolution, telephone line conditions and capability of the other
party’s machine.
2
 Transmission speed is based upon the ITU-T No. 1 Test Chart with original mode. If the capability of the other party’s machine is
inferior to your unit, the transmission time may be longer.
3
 If an error occurs during fax reception, such as a paper jam or if the recording paper runs out, the fax and subsequent faxes will
be retained in memory.
4
 Recording time may be reduced by the calling party’s background noise.
3.2.
Cordless Handset
3.3.
Charger Unit
Note:
• Design and specifications are subject to change without notice.
• The pictures and illustrations in these instructions may vary slightly from the actual product.
Applicable Lines:
Public Switched Telephone Network
Document Size:
Max. 216 mm in width
Max. 600 mm in length
Effective Scanning Width:
208 mm
Recording Paper Size:
216 
× max. 30 m roll
Effective Printing Width:
208 mm 
Transmission Time*
1
:
Approx. 12 s/page (Original mode)*
2
Scanning Density:
Horizontal: 8 pels/mm
Vertical: 
3.85 lines/mm - in standard resolution,
7.7 lines/mm - in fine/photo resolution,
15.4 lines/mm - in super fine resolution
Photo resolution:
64-level
Scanner Type:
Contact Image Sensor
Printer Type:
Thermal printing
Data Compression System:
Modified Huffman (MH), Modified READ (MR)
Modified Modified Read (MMR)
Modem Speed:
9,600 / 7,200 / 4,800 / 2,400 bps; Automatic Fallback
Operating Environment:
5 - 35
°C, 20 - 80% RH (Relative Humidity)
Dimensions (H
×W×D):
Approx. height 121 mm 
× width 364 mm × depth 224 mm 
Mass (Weight):
Approx. 2.8 kg
Power Consumption:
Standby: Approx. 2.5 W
Transmission: Approx. 16 W
Reception: Approx. 35 W (When receiving a 20% black document)
Copy: Approx. 40 W (When copying a 20% black document)
Maximum: Approx. 130 W (When copying a 100% black document)
Power Supply:
220 V - 240 V  AC, 50/60 Hz
Fax Memory Capacity*
3
:
Approx. 25pages of memory transmission
Approx. 28pages of memory transmission/reception
(Based on the ITU-T No. 1 Test Chart in standard resolution, with original mode.)
Voice Memory Capacity*
4
:
Approx. 15 minutes of recording time
Standard:
DECT (Digital Enhanced Cordless Telecommunications)
GAP (Generic Access Profile)
Number of channels:
120 Duplex channels
Frequency range:
1.88 GHz to 1.9 GHz
Duplex procedure:
TDMA (Time Division Multiple Access)
Channel spacing:
1,728 kHz
Bit rate:
1,152 kbit/s
Modulation:
GFSK
RF Transmission Power:
Approx. 250 mW
Operating environment:
0 C - 40 C, 20 % - 80 % RH (Relative Humidity)
Operation range:
Up to 300 m outdoors, Up to 50 m indoors, depends on the condition.
Dimensions:
Approx. height 158 mm 
× width 48 mm × depth 30 mm
Mass (Weight):
Approx. 130 g
Operating environment:
0 - 40
°C, 20 - 80% RH (Relative Humidity)
Dimensions:
Approx. height 52 mm 
× width 75 mm × depth 88 mm
Mass (Weight)
Approx. 60 g
Power supply:
AC adaptor (220V-240V AC, 50/60 Hz)
11
KX-FC965RU-T
4 General/Introduction
4.1.
Optional Accessories
*
Use only the included or specified recording paper. Using other recording paper may affect print quality and/or
cause excessive wear to the thermal head.
4.2.
Translation Lists
4.2.1.
Error Messages (Report)
4.2.2.
Error Messages (Display)
Model No.
Item
Specifications/Usage
 KX-A106
 Standard thermal recording paper*
1
216 mm 
× 30 m roll, with 25 mm core 
P03P or HHR-4MRE
 Rechargeable battery
2 rechargeable nickel metal hydride (Ni-MH) batteries 
KX-TGA641RU
 Additional cordless  handset
-------------------
 KX-A272
 DECT repeater
-------------------
12
KX-FC965RU-T
4.2.3.
Cordless Handset
5 Features
General
• LCD (Liquid Crystal Display) readout
Facsimile
• Automatic document feeder (10 sheets)
• Resolution: Standard/Fine/Photo/Super Fine (64 level)
• Broad cast 
Integrated Telephone System
• Redialing function
• Base unit phonebook function (100 names)
• Cordless handset phonebook function (100 names)
• Caller ID compatible**
**Feature requires a subscription to caller identification ser-
vices offered by certain local telephone companies for a tee.
You and your caller(s) must be in areas that provide caller
identification services, and compatible equipment must be
used by both telephone companies. Feature not available
when the unit is connected to a PBX system.
Enhanced Copier Function
• 64-Level halftone
Page of 127
Display

Click on the first or last page to see other KX-FC965RU service manuals if exist.