Panasonic DMR-EZ47VEB Service Manual ▷ View online
9.8. RAM/Digital P.C.B. Module
1. Remove the 3 Screws (A) to remove DVD Drive.
2. Remove the Digital Barrier.
3. Remove the 2 FFCs and 3 Screws (B) to remove the Digital
Shield and Digital P.C.B..
4. Put the RAM/ Digital P.C.B. Module as follow figure, remove
the Digital Shield.
37
DMR-EZ47VEB
5. Put Digital P.C.B. on DVD drive and remove RAM/Digital
P.C.B. Module.
Note:
RAM/Digital P.C.B. Module as service part has no heat sink
and heat transfer sheet.
Before returning to customer, heat sink and heat transfer
sheet should be installed on Digital P.C.B..
and heat transfer sheet.
Before returning to customer, heat sink and heat transfer
sheet should be installed on Digital P.C.B..
9.9. DV Jack P.C.B.
1. Remove 2 Screws (A) to remove DV jack P.C.B..
38
DMR-EZ47VEB
9.10. Rear Panel, Fan Motor
9.10.1. Only Fan Motor
1. Disconnect Fan Connector.
2. Remove 2 Screws (A) to remove Fan Motor.
2. Remove 2 Screws (A) to remove Fan Motor.
9.10.2. Rear Panel with Fan Motor
1. Disconnect Fan Connector.
2. Remove 6 Screws (B) and 2 Screws (C).
3. Unlock 2 Locking Tabs (A) to remove Rear Panel with Fan
2. Remove 6 Screws (B) and 2 Screws (C).
3. Unlock 2 Locking Tabs (A) to remove Rear Panel with Fan
Motor.
9.11. HDMI P.C.B.
1. Remove the Screw (A) to remove the PCB Angle.
2. Peel off the Himeron Sheet and disconnect the FFC, pull
out the HDMI P.C.B. in the direction of arrow.
39
DMR-EZ47VEB
9.12. Dig. Interface P.C.B.
1. Remove 4 Screws (A) to remove DVD Angle.
2. Disconnect 4 Connectors and remove 4 Screws (B) to
remove the Dig. Interface P.C.B..
9.13. Backend P.C.B.
1. Pull out the Backend P.C.B. in the direction of arrows.
9.14. Main P.C.B.
1. Disconnect 4 Connectors.
2. Remove 3 Screws (A) and remove Main P.C.B..
2. Remove 3 Screws (A) and remove Main P.C.B..
40
DMR-EZ47VEB
Click on the first or last page to see other DMR-EZ47VEB service manuals if exist.