Panasonic DMP-BDT210EE Simplified Service Manual ▷ View online
32
10.1.6.
Rear Panel
1. Remove the 4 screws (A) and screw (B).
2. Unlock 2 locking tabs (A) to remove the Rear Panel.
2. Unlock 2 locking tabs (A) to remove the Rear Panel.
10.1.7.
SD USB P.C.B.
1. Remove the wire with connector (A).
2. Remove the screw (A) and screw (B) to remove SD USB
2. Remove the screw (A) and screw (B) to remove SD USB
P.C.B..
10.1.8.
Wireless LAN Module
1. Remove the wire with connector (A).
2. Remove the 2 screws (A) to remove the Wireless LAN
2. Remove the 2 screws (A) to remove the Wireless LAN
Module.
3. Remove the screw (B) to remove the WIFI Angle.
10.1.9.
BD Power P.C.B.
1. Remove the wire with connector (A) and connector (B).
2. Remove the 2 screws (A) to remove BD Power P.C.B..
2. Remove the 2 screws (A) to remove BD Power P.C.B..
33
10.1.10. Drive Unit
1. Remove the FFC (A), and isolate it with an ESD preven-
tion bag (RPFC0114).
2. Remove the FFC (B), FFC (C) and FFC (D).
3. Remove the 4 screws (A) to remove Drive Unit.
3. Remove the 4 screws (A) to remove Drive Unit.
10.1.11. BD Digital P.C.B.
1. Remove the 2 screws (A) to remove BD Digital P.C.B..
34
10.2. Drive Unit
10.2.1.
Tray Unit
1. Insert the paper clips, etc. into the hole of the bottom side,
and slide it to the direction of arrow until it can be.
2. Pull the Tray Unit to the direction of arrow until it can be.
3. Insert the paper clips, screw drivers, etc. to open the tabs,
and pull the Tray Unit.
10.2.2.
Pulley Gear, Belt
1. Perform the step “10. 2. 1. Tray Unit”.
2. Push the Post to the direction of arrow by using the slot-
2. Push the Post to the direction of arrow by using the slot-
ted screwdriver.
3. Remove the Pulley Gear and Belt.
35
10.2.3.
Slide Cam, Traverse Base
1. Perform the step “10. 2. 2. Pulley Gear, Belt”.
2. Open the connector lock, and disconnect the FFC.
2. Open the connector lock, and disconnect the FFC.
3. Open the connector lock, and disconnect the FFC.
4. Remove the 2 Screws (C), and remove the Traverse
4. Remove the 2 Screws (C), and remove the Traverse
Base Ass’y with spreading the 2 hooks to the direction of
arrows.
arrows.
5. Slide the Slide Cam to right, then lift up the Traverse
base.
6. Remove the Traverse base with spreading the 2 hooks to
direction of arrows.
7. Slide the Slide Cam to right, then open the tabs and
remove the Slide Cam.
Click on the first or last page to see other DMP-BDT210EE service manuals if exist.