Panasonic H-FS14140PP / H-FS14140E / H-FS14140GK Service Manual ▷ View online
9
4
Disassembly and Assembly Procedure
4.1.
Outline
It is recommended dealing with clean box, to keep maintaining the dustproof environment.
(Refer to “3.2. Clean Box” section of this service manual for details.)
And, please refer to "5.1.2. Dust / Dirt on the Lens Glasses" when cleaning the inside of the lens
Important:
(Refer to “3.2. Clean Box” section of this service manual for details.)
And, please refer to "5.1.2. Dust / Dirt on the Lens Glasses" when cleaning the inside of the lens
Important:
1. When servicing the enclosure part (refer to Fig. W1), it must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000 (Federal Standard 209D))
As for procedure, refer to the “5 Maintenance” for details.
As for procedure, refer to the “5 Maintenance” for details.
2. To minimize the possibilities/risk of getting the dust/dirt on the lens surface, keep covering the lens unit with lens caps (front &
rear), other than necessary cases.
3. Do not touch the surface of the lens glasses with your fingers.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).
Proceed disassemble/assemble, by referring the following table and Fig. W1.
NOTE:
1. When installing the screws, be sure to use the torque driver (RFKZ0456) and tighten the screws with specified torque, men-
tioned on the following table.
2. Use VFK1390 (small driver) when screwing Ref. B212.
Interchangeable Lens (H-FS14140)
10
11
4.2.
Disassembly procedure
Important:
It must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000 (Federal
Standard 209D))
(Satisfied clean level: Less than class 10,000 (Federal
Standard 209D))
4.2.1.
Removal of the Decoration Ring
1. Decoration ring is sticked on the 1st lens frame unit.
2. Put the sheet so that the lens glass is fully covered.
3. Insert the the small flat blade screwdriver to Gap
2. Put the sheet so that the lens glass is fully covered.
3. Insert the the small flat blade screwdriver to Gap
(between the decoration ring and lens glass), and peel off
the decoration ring gently.
the decoration ring gently.
4.2.2.
Removal of the Filter ring
1. Remove the 3 screws (A).
4.2.3.
Removal of the Shading frame
1. Remove the 2 screws (B).
12
4.2.4.
Removal of the L mount unit
1. Remove 1 screw (C) and 3 screws (D).
4.2.5.
Removal of the Rear frame unit
1. Remove 3 screws (E) and disconnect 1 connector.
4.2.6.
Removal of the Lens P.C.B.unit and
the Lens mount contact unit
the Lens mount contact unit
1. Disconnect 4 connectors.
Click on the first or last page to see other H-FS14140PP / H-FS14140E / H-FS14140GK service manuals if exist.