Panasonic SA-PM24EB / SA-PM24EG / SA-PM24EP / SC-PM24EP Service Manual ▷ View online
49
10.2. Assembling Procedures
Caution : Removal of the short pin is necessary for
replacement of new traverse unit.
replacement of new traverse unit.
Step 1 : Release the guide.
Step 2 : Push the traverse slide plate (rib), ensure both grooves
are opened.
Step 2 : Push the traverse slide plate (rib), ensure both grooves
are opened.
50
Step 3 : Slot the traverse unit at approximately 45° into the
mecha chassis as arrow shown.
Caution : Ensure the bosses fix exactly onto the guides.
mecha chassis as arrow shown.
Caution : Ensure the bosses fix exactly onto the guides.
Step 4 : Release the guide.
Step 5 : Push the traverse slide plate (rib) to lock the traverse
unit in.
Step 5 : Push the traverse slide plate (rib) to lock the traverse
unit in.
51
11 Service Position
Note: For description of the disassembly procedures, see the Section 9.
11.1. Checking and Repairing of
USB P.C.B.
Step 1 : Remove the Top Cabinet Assembly.
Step 2 : Release both locators.
Step 3 : Release 3 catches from the bottom.
Step 4 : Slightly detach and move the Front Panel Assembly as
arrow shown.
Step 2 : Release both locators.
Step 3 : Release 3 catches from the bottom.
Step 4 : Slightly detach and move the Front Panel Assembly as
arrow shown.
Step 5 : Remove 2 screws.
Step 6 : Remove USB Assembly.
Step 6 : Remove USB Assembly.
Step 7 : Place a support block underneath the USB P.C.B.
Step 8 : Check and repair USB P.C.B. according to the diagram
shown.
Step 8 : Check and repair USB P.C.B. according to the diagram
shown.
52
11.2. Checking and Repairing of
Panel P.C.B.
Step 1 : Remove the Top Cabinet Assembly.
Step 2 : Remove the Front Panel Assembly.
Step 3 : Remove the USB Assembly.
Step 4 : Remove the Panel P.C.B.
Step 5 : Place a support block underneath the USB P.C.B.
Step 6 : Connect 22P FFC at the connector (CN802) on Main
P.C.B.
Step 2 : Remove the Front Panel Assembly.
Step 3 : Remove the USB Assembly.
Step 4 : Remove the Panel P.C.B.
Step 5 : Place a support block underneath the USB P.C.B.
Step 6 : Connect 22P FFC at the connector (CN802) on Main
P.C.B.
Step 7 : Lay an insulating material on Panel P.C.B.
Step 8 : Attach extension cable REEX1021 (10P FFC from
CN451 on Main P.C.B. to CN900 on Panel P.C.B.).
Step 9 : Connect 4P Cable at the connector (CN5902) on
Transformer P.C.B.
Step 10 : Check and repair Panel P.C.B. according to the dia-
gram shown.
Step 8 : Attach extension cable REEX1021 (10P FFC from
CN451 on Main P.C.B. to CN900 on Panel P.C.B.).
Step 9 : Connect 4P Cable at the connector (CN5902) on
Transformer P.C.B.
Step 10 : Check and repair Panel P.C.B. according to the dia-
gram shown.
Click on the first or last page to see other SA-PM24EB / SA-PM24EG / SA-PM24EP / SC-PM24EP service manuals if exist.