Panasonic SA-PM24EB / SA-PM24EG / SA-PM24EP / SC-PM24EP Service Manual ▷ View online
45
Step 3 : Mount the heatsink unit with Transistor (Q5901) on the
Transformer P.C.B.
Transformer P.C.B.
Step 4 : Solder pins of the Transistor (Q5901).
Step 5 : Twist the pins of heatsink unit by 45
°
in an anti-clock-
wise or clockwise direction.
Step 6 : Solder pins of the heatsink unit.
Caution : Ensure pins of the Transistor (Q5901) and heat-
sink unit are properly seated and soldered on the Trans-
former P.C.B.
Step 6 : Solder pins of the heatsink unit.
Caution : Ensure pins of the Transistor (Q5901) and heat-
sink unit are properly seated and soldered on the Trans-
former P.C.B.
9.16. Disassembly of CD Mecha-
nism Unit (DLS6C)
• Refer to “Disassembly of Top Cabinet Assembly”.
• Refer to “Disassembly of Front Panel Assembly”.
• Refer to “Disassembly of Front Panel Assembly”.
Step 1 : Remove 2 screws.
Step 2 : Detach 22P FFC at the connector (CN807) on Main
P.C.B.
Step 2 : Detach 22P FFC at the connector (CN807) on Main
P.C.B.
46
Step 3 : Slightly tilt the CD Mechanism Unit (DLS6C) and pull
out as shown.
out as shown.
9.17. Disassembly of CD Servo
P.C.B.
• Refer to “Disassembly of CD Mechanism Unit (DLS6C)”.
Step 1 : Remove 3 screws.
Step 2 : Unsolder 4 points.
Step 2 : Unsolder 4 points.
Step 3 : Move up the CD Servo P.C.B.
Step 4 : Flip the CD Servo P.C.B.
Step 4 : Flip the CD Servo P.C.B.
47
Step 5 : Detach 16P FPC at the connector (CN7001) on CD
Servo P.C.B.
Servo P.C.B.
48
10 Disassembly and Assembly of Traverse Unit
10.1. Disassembling Procedures
Step 1 : Release the guide.
Step 2 : Push the traverse slide plate (rib), ensure both grooves
are opened.
Step 2 : Push the traverse slide plate (rib), ensure both grooves
are opened.
Step 3 : Slide out the traverse unit as arrow shown.
Caution : Ensure the OPU is face upwards, avoid touching
the surface of the traverse unit.
the surface of the traverse unit.
Click on the first or last page to see other SA-PM24EB / SA-PM24EG / SA-PM24EP / SC-PM24EP service manuals if exist.