LG WT1101CW Service Manual ▷ View online
21
2) Disassembly of the Noise Filter,
Power Cord, Inlet Valve, Pressure
Switch, and Dispenser Housing.
①
Remove 2 screw attaching the panel on the back.
②
Disassemble the rear panel.
Noise Filter and
Power Cord
①
Remove the two
screws attaching the
noise filter.
②
Disconnect both
connectors in the
noise filter.
Remove the power
cord from the noise
filter.
Inlet Valve
①
Disconnect the
leads from the inlet
valve and remove
three screws.
②
Remove the hoses
and output pipes
from the input
valve.
③
Remove the inlet
valve.
Pressure Switch
①
Disconnect the leads
from pressure switch
and detatch the
pressure switch from
the machine.
②
Disconnect the
pressure tube from
the pressure switch.
Dispenser
Housing
①
Remove the hoses
and output pipes
from the input
valve.
②
Disassemble the
connector pipe and
the dispenser
housing.
22
3) Disassembly of Top Cover and Lid
①
Remove the hinge cover.
②
Remove 3 hinge screw
③
Pull the hinge to the left and right.
④
Remove the hinge.
23
4) Disassembly of Tub Cover and Pulsator
①
Remove 8 screws and take off the tub cover.
②
Remove the pulsator cap.
③
Remove the pulsator screws.
④
Remove the pulsator washer.
Tub Cover
Pulsator Cap
Pulsator
Screw
Pulsator
Inner Tub Cap
Hub Fixing Nut
Outer Tub
Inner Tub
Inner Tub
Stator
Rotor Nut
Hub Attachment Nut
Shaft
Bearing Housing ASM
Rotor
Inner
Tub Cap
①
Hit the bar using the hammer. ②
Disconnect hub nut and disassemble the inner tub.
5) Assemble the service tool (38 mm wrench)
6) Remove the hub attachment nut. (38 mm)
24
9) Disassembly of Rotor and Stator
①
Use a wrench (M24) to remove the nut that
connects the rotor to the shaft.
(The torque should be 200 kgf/cm or 88 foot-
pounds.)
②
Remove the rotor by pulling it straight off the
splined shaft.
7) Disassembly of the Back Cover and
Drain Pump
①
Remove the screws that attach the back cover and
take it off.
②
Disconnect the leads and the drain hose from the
drain pump.
③
Remove the pump attachment screws and the lead
connector. Take the pump assembly out of the
washer.
8) Disassembly of Damper Assembly
①
Remove the top cover of the washing machine.
②
As shown in the drawing, lift the damper assembly
and remove it along with the outer tub assembly.
③
Damper assembly shall not be disassembled.
Replace damper as assembly.
Click on the first or last page to see other WT1101CW service manuals if exist.