LG WM-12316FD Service Manual ▷ View online
27
①
Disconnect the wiring connector.
②
Remove the valve by two screws of the valve
holder.
When reconnecting the connector
INLET VALVE
1
2
3 Option
VALVE
(PRE-WASH)
GY/WH - BK
VALVE
(NORMAL-WASH)
WH/BK - BK
VALVE
®È
(NORMAL-WASH)
BL/RD - BK
VALVE
(HOT)
BL/RD - BK
①
Open the door completely.
②
Remove the two screws from the hinge.
※
When removing the Door Assembly, it is
necessary to hold the Bracket that is inner of
the Cabinet Cover.
the Cabinet Cover.
Pull it out from hose.
※
First, prepare a bucket to put in the remained
water.
CAP
(REMAINING HOSE)
DOOR
Removing method of remained water
28
①
The cabinet gasket clamp is released.
②
Two screws are unscrewed from the cabinet
cover.
cover.
①
Pull plat(-) screwdriver or pully knife into the
both sides of filter cover, and pull in out.
both sides of filter cover, and pull in out.
①
Unscrew the screw from the lower side of the
cabinet cover.
①
Unscrew the 2 screw from upper of the cabinet
cover.
GASKET ASSEMBLY
29
①
Disassemble the clamp assembly.
①
Remove dry gasket clamp by loosening the
screw.
screw.
①
When reassembling the gasket, put the drain
hole of the gasket downward, then assemble.
hole of the gasket downward, then assemble.
Drain Hole
Tub Gasket
Clamp
Clamp
30
①
Remove the back cover.
②
After loosening the bolt, Rotor, pull out the
rotor.
①
Remove the 6 bolt from the stator.
②
Disconnect the 2 connectors.
①
Remove the hinges (Damper) at the Tub.
②
The Hinge(Damper) at the base is pulled off
pressing on the snaps at the sharp end.
pressing on the snaps at the sharp end.
③
The hinge at the base is pulled off.
(To arrow direction)
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
Rotor
Bolt
Friction
Damper
Damper
Hinge
(Damper)
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
(FRICTION DAMPER)
HOW TO ASSEMBLE THE MOTOR
Click on the first or last page to see other WM-12316FD service manuals if exist.