LG WF-T9030TDW Service Manual ▷ View online
4-2. DIAGRAMA DE CABLEADO
B) Series WFT75B30(1)A(B) / WFT85B30(1)D(E) / WF-T75B30AD/
/ WF-T850IS
WF-T8030TD / WF-T9030TD
29
4-2. WIRING DIAGRAM
A)Series WFT60A30(1)A(B,C) / WFT65A30(1)D(E,F) / WF-T6530TD
WFT70A30(1)D(E,F)
30
4-3. PROGRAM TIME CHART
1) Series WFT60A30(1)A(B,C) / WFT65A30(1)D(E,F) / WFT70A30(1)D(E,F)
WF-T6530TD
!"
Contents of changed algorithm by the sensor
Algorithm change :
The algorithm is automatically changed to operate at the optimum condition according to the condition detected by the sensor
.
LED Display
Orange
Green
Red
W
ash Condition
Low T
emperature
High Hardness Little Detergent
Moderate Condition
High T
emperature
Low Hardness Much Detergent
Change Factor
W
ash time
W
ash time
W
ash pattern (Off time)
Spin time Rinse w
. level
Rinse times
Change Level
Max +8 min.
Max -4 min. Max +0.2 sec. Max +2 min. Max -0.2kHz Deep rinse addition
31
4-3. TA B LA D E TIE M PO D E PR OG R A M A S
2) Series WFT75B30(1)A(B) / WFT85B30(1)D(E) / WF-T75B30AD /
WF-T8030TD / WF-T9030TD
Contents of changed algorithm by the sensor
Algorithm change :
The algorithm is automatically changed to operate at the optimum condition according to the condition detected by the sensor
.
LED Display
Orange
Green
Red
W
ash Condition
Low T
emperature
High Hardness Little Detergent
Moderate Condition
High T
emperature
Low Hardness Much Detergent
Change Factor
W
ash time
W
ash time
W
ash pattern (Off time)
Spin time Rinse w
. level
Rinse times
Change Level
Max +8 min.
Max -4 min. Max +0.2 sec. Max +2 min. Max -0.2kHz Deep rinse addition
32
4-4. ADJUSTMENT
1) Brake lever adjustment
• Shown as in the figure, untighten the adjustment
screw to keep clearance less than 1.9°æ0.1mm
between the tip and the brake lever.
And turn on the lock nut then paint it red.
• Painting part is adjusted in factory, it does not
need adjusting.
• Adjust the screw properly if the brake doesn't
work during spin.
CAUTION
2) Keeping clearance
• Keep the clearance about 2.0~3.5mm between
brake lever and P.V link as shown in the figure.
• Clutch pulley must be turning to one side P.V
Link is pulling the brake Lever.
• Clutch pulley must be turning to the left and the
right when P.V Linke does not pull the brake
Lever.
CAUTION
3) V-belt adjustment
• Adjust the motor pulley by pushing the motor like
arrow , to make V-belt tension parallel when
pushed at the point of arrow .
• When the V-belt is not properly adjusted, the
motor will not be running or the belt will be
slipping.
CAUTION
Click on the first or last page to see other WF-T9030TDW service manuals if exist.