DOWNLOAD LG WF-T15D80EP Service Manual ↓ Size: 11.46 MB | Pages: 58 in PDF or view online for FREE

Using the Liquid Bleach Dispenser

Using the Dispenser Drawer

1.  Check clothing care labels for special instructions. 
2.  Measure liquid bleach carefully, following instructions on the

bottle.

Never pour undiluted liquid chlorine bleach directly onto clothes
or into the wash basket.
Do not pour powdered bleach into bleach dispenser.
Avoid overfilling or splashing when adding bleach to the
dispenser. The maximum capacity of the bleach dispenser is
one cup of bleach per wash cycle. Overfilling could result in
early dispensing of bleach.  

3.  Before starting the washer, pour measured amount of bleach

directly into bleach dispenser. If you prefer to use powdered
bleach, add it into the wash basket directly before adding clothes. 

The dispenser drawer contains three compartments:

Liquid Fabric Softener
Liquid or Powder Detergent
Liquid Wash Boost Additives

1. Slowly open the dispenser drawer by pulling the drawer out

until it stops.

2. After adding laundry products, slowly close the dispenser

drawer. Closing the drawer too quickly could result in early
dispensing of additives.

Avoid overfilling or splashing when adding laundry products
to the dispenser. Doing so could result in early dispensing of
laundry products.

At the end of the cycle, you may see water in the
compartments. This is part of the normal operation of the
washer.

NOTE: Do not use bleach in the dispenser drawer.

Adding Detergent

Adding Fabric Softener

Adding Wash Boost Additives

Add measured detergent to the detergent compartment of
the dispenser drawer.

Detergent is flushed through the dispenser at the
beginning of the wash phase. Either powdered or liquid
detergent can be used.

Detergent usage may need to be adjusted for water
temperature, water hardness, size and soil level of the
load. Avoid using too much detergent in your washer, as it
can lead to oversudsing and detergent residue being left
on the clothes.

If desired, pour the recommended amount
of liquid fabric softener into the left-hand
compartment. Use only liquid fabric softener.

Dilute with water to the maximum fill line.

Overfilling can cause early dispensing of the
fabric softener, which could stain clothes.

NOTE : Do not pour fabric softener directly on the wash load. It

may stain the clothes.

The Wash Boost dispenser may be used to
clean heavily soiled or stained garments 
more efficiently.

If desired, place the additives for the 
wash Boost setting in the right-hand
compartment. Use only liquid additives.

Overfilling can cause early dispensing of
presoak additives, which could result in
damaged clothes.

NOTE : Do not pour additives directly on the wash load. It may stain the clothes.clothes.

Do not use or mix liquid chlorine bleach with other household chemicals such as toilet cleaners, rust removers, acid or products
containing ammonia. These mixtures can produce dangerous fumes which can cause serious injury or death.

To reduce the risk of fire or serious injury to persons or property, comply with the basic warnings listed below:

Read and comply with all instructions on stain removal products.
Keep stain removal products in their original labeled containers and out of children's reach.
Thoroughly wash any utensil used.
Do not combine stain removal products, especially ammonia and chlorine bleach. Dangerous fumes may result.
Never wash items which have been previously cleaned in, washed in, soaked in or spotted with gasoline, dry cleaning solvents
or other flammable or explosive substances because they give off vapors that could ignite or explode.
Never use highly flammable solvents, such as gasoline, inside the home. Vapors can explode on contact with flames or
sparks.

Remove stains promptly.
Determine the kind of stain, then follow the recommended treatment in the stain  removal
chart below.
To pretreat stains, use a prewash product, liquid Detergent, or a paste made from
granular Detergent and water.
Use COLD water on unknown stains because HOT water can set stains.
Check care label instructions for treatments to avoid on specific fabrics.
Check for colorfastness by testing stain remover on an inside seam.
Rinse and wash items after stain removal. 

STAIN

TREATMENT

Adhesive tape, chewing gum,
rubber cement

Beverages (coffee, tea, soda, juice,
alcoholic beverages)

Blood

Candle wax, crayon

Chocolate

Collar or cuff soil, cosmetics

Dye transfer on white fabric

Grass

Ink

Mildew, scorch

Mud

Mustard, tomato

Nail polish

Paint, varnish

Rust, brown or yellow
discoloration

Shoe polish

Grease, oil, tar (butter, fats, salad
dressing, cooking oils, car grease,
motor oils)

Pretreat or soak in WARM water using product containing enzymes. Wash using bleach safe for fabric.

Pretreat with prewash stain remover or rub with bar soap.

Use packaged color remover. Wash using bleach safe for fabric.

Pretreat or soak in WARM water using product containing enzymes. Wash using bleach safe for fabric.

Scrape residue from fabric. Pretreat. Wash using hottest water safe for fabric. For heavy stains and tar,
apply nonflammable dry cleaning fluid to back of stain. Replace towels under stain frequently. Rinse
throughly. Wash using hottest water safe for fabric.

Some inks may be impossible to remove. Washing may set some inks. Use prewash stain remover,
denatured alcohol or nonflammable dry cleaning fluid.

Wash with chlorine bleach if safe for fabric. Or, soak in oxygen bleach and HOT water before washing. Badly
mildewed fabrics may be permanently damaged.

Brush off dry mud. Pretreat or soak with product containing enzymes.

Pretreat with prewash stain remover. Wash using bleach safe for fabric.

May be impossible to remove. Place stain face down on paper towels. Apply nail polish remover to back of stain.
Repeat, replacing paper towels frequently. Do not use on acetate fabrics.

WATER BASED : Rinse fabric in cool water while stain is wet. Wash. Once paint is dry, it cannot be removed, 
OIL BASED AND VARNISH : Use solvent recommended on can label. Rinse throughly before washing.     

For spots, use rust remover safe for fabric. For discoloration of an entire load, use phosphate Detergent and
nonchlorine bleach. Do not use chlorine bleach because it may intensify discoloration.     

LIQUID : Pretreat with a paste of granular Detergent and water. PASTE : Scrape residue from fabric. Pretreat with
prewash stain remover or nonflammable dry cleaning fluid. Rub Detergent into dampened area, Wash using bleach
safe for fabric.

Apply ice. Scrape off excess. Place stain face down on paper towels. Saturate with prewash stain remover or
nonflammable dry cleaning fluid.

Use product containing enzymes to pretreat or soak stains.

Pretreat stain. Wash using COLD water and bleach safe for fabric.

Rinse with COLD water. Rub with bar soap. Or pretreat or soak with product containing enzymes. Wash using bleach safe
for fabric.
Scrape off surface wax. Place stain face down between paper towels. Press with warm iron until wax is absorbed.
Replace paper towels frequently. Treat remaining stain with prewash stain remover or nonflammable dry cleaning fluid.
Hand wash to remove solvent. Wash using bleach safe for fabric.

Baby formula, dairy products, egg

Use to turn the power on or off. 
Push again and power goes on or off 
The power goes off automatically about 10
seconds  after the wash is finished.

These buttons can be selectable for every
program.

Soak : It gives additional 30 min Soak.
(Except for Wool, Delicate, Rinse/Spin,
Spin Only)  

Spin Hold: It gives gentle spin instead of
normal spin (Except for Wool, Delicate,
Wash Only)  

Use to set a delayed finishing time.
The time increases when the button is pushed.
The following settings are indicated as the button
is pushed 3  

4   

5   

... 11  

12  

14

16   

...46   

48  

3 HOUR.

To cancel delay time, turn the power switch off. 

This button
allows you to
store a
customized
wash cycle for
future use . 

This button allows you to select
the strength of the wash action. 
Power option selections light up
in sequence as follows Medium

Heavy

Light 

Medium as

the button is pushed. 
This can be selected for any
program, but when washing
Heavy, it starts with Heavy. 
Adjustment can be made while
washing. 

• It only operates in FUZZY Program.
• During being detected by the sensor, the LED flashes green, orange 

and red in turn. And, after detecting, the LED lights a specific color according to
the detecting condition as follows:  

If the current washing condition (Detergent quantity, Water Temperature, water
quality, etc.) is determined as better than the standard one, it optimizes the
algorithm to save the energy by decreasing washing time/strength,  and the LED
automatically turns to red.  
If the current washing condition is determined as worse than the standard one, it
optimizes the algorithm by increasing washing time/strength, and the LED
automatically turns to orange.
If the current washing condition is determined as equal to the standard one, the
algorithm has no change and the LED turns to green.

* For optimizing the washing algorithm, the displaying time may be changed during washing-increased by 8minutes at

maximum and decreased by 4 minutes at maximum.

* If the Detergent quantity is put more than the standard, for increasing the rinsing performance, it automatically adds rinsing,

and the remaining time may be increased.

* The standard detected by the sensor changing the algorithm is set by the normal standard. It may not be same to the washing

habit of a specific user. So, it does not matter that the user uses it according to her/his washing habit.