DOWNLOAD LG WF-S950CP Service Manual ↓ Size: 4.64 MB | Pages: 59 in PDF or view online for FREE

Turn the power switch on by pressing WATER LEVEL+STAIN LEVEL+RESERVATION button together.

Test mode : Only I-SENSOR LED is on and display shows current sensing mode

: temperature &  conductivity sensing is disabled

: temperature sensing is enabled, but conductivity is disabled.

: temperature &  conductivity sensing is enabled

1. Press WATER LEVEL BUTTON once:       

Press WATER LEVEL BUTTON again : power off

2. Press RINSE BUTTON once: 

Press RINSE BUTTON again : power off

3. Press START/PAUSE BUTTON once:  

Press START/PAUSE BUTTON again : power off

Turn the power switch on by pressing WATER LEVEL + PROGRAM and STAIN LEVEL button together.

Initial Test mode display : All LEDs are off,except I-SENSOR LED

Display the number of TR calibration times : Display “      ” means not calibrated, “     ” for the 
first time and so on.

1. Press Program button once: Display the current Controller Group (1~26)

Program button again : Decrease the controller group by one (display the changed group)
Program button to decrease by one

2. Press START/PAUSE button once : Display the current Controller Group (1~26)  

Press START/PAUSE button again : increase the controller group by one (display the changed group)
START/PAUSE button to increase by one

The buzzer sounds if there is no controller group.

Initial operation: Press "RESERVATION" + "START/PAUSE" botton together after power on, and  press
"RESERVATION" button only again
(displaying the number of pressing button and each data every 0.5 second)

< Fig1 >

Sensor

Terminal

of Controller

How to Connect

• Loosening the front panel of the washing machine

and connect the sensor connecting terminal with
the terminal of the jig.

After supplying water to the washing bath, agitate
for one minute before using the jig.
Record the sensed value of the sensor attached
to the current product at Test mode.
Connect the jig, put the jig sensor into the
washing bath, and record the sensed value of the
sensor.
Determine the sensor performance by comparing
the value measured by the jig and the value
measured by the sensor attached to the product.

1 times : TR Controller Group ( 1 ~ 26 )
2 times : Check the temperature sensor codition

0  : Normal

99 : Temperature senosr’s error, 

(Stop sensing for Temperature and Hardness)

3 times : Temperature of supplied water
4 times : Increment/decrement of washing time according to temperature
5 times : Washing stream at Motor off according to temperature
6 times : The number of comparing the conductivity of washing with rinsing conductvity 

0 ~ 9 : Normal

99 : Abnormal (Stop the sensing of Hardness)

7 times : Sensored result (0 ~ FF:  hexadecimal is displayed)

.
.
.

18 times : Initial stage

5. EXPLODED VIEW

TUB ASSEMBLY

TOP COVER
ASSEMBLY

CABINET
ASSEMBLY

A010 

A230 

A240 

A200 

A190 

A151 

A160 

A210 

A160 

A220 

A020 

A030 

A040 

A052 

A060 

5-1. THE EXPLODED VIEW OF TOP COVER ASSEMBLY

: Non-Service Part

HOT(ORANGE)

COLD(BLUE)

HOT(ORANGE)
COLD(BLUE)

HOT(ORANGE)

COLD(BLUE)

A270

A181

A184

HOT(ORANGE)

COLD(BLUE)

COLD(BLUE)

A185