DOWNLOAD LG WD1351RD / WD1357RD Service Manual ↓ Size: 5.73 MB | Pages: 43 in PDF or view online for FREE

Are receptacles correctly connected to
the terminals of the DRY DUCT
ASSEMBLY?

After power off, is the resistance of
dry heater 10 ~ 40Ω?

Reconnect the

receptacle

Replace the dry heater.

Replace the thermostat.

Replace the
PWB ASSEMBLY(Main)

When checking voltage between connectors
( 

, 

) on drying, is the voltage

AC 220-240V as the figure?
(wire color :

-YL , 

- BK)

Is thermostat closed?

(1)

(1)

(2)

(3)

Is it disconnected, or disassembled?

(1)-Yellow, 3pin

When checking woltage between connectors

(1)~(2), (2)~(3)

on drying, is the

voltage DC 20~30V as the figure?

wire color: (1)-White, (2)-Black

(3)-Yellow

Reconnect or
repair connector.

Replace the
PWB ASSEMBLY(Main)

Replace the DRY FAN
ASSEMBLY.

Check the motor connector, is the resistance
of terminal same as the figure?
Resistance of terminal : 

- 

2~5Ω

- 

: 2~5Ω

9.DISASSEMBLY INSTRUCTIONS

Disassemble and repair the parts after pulling out power cord from the outlet.

TOP PLATE ASSEMBLY

PANEL ASSEMBLY, CONTROL

PWB ASSEMBLY(DISPLAY)

PANEL ASSEMBLY(RAWER)

Unscrew 2 screws on the back of the top plate.

Pull the top plate backward and upward as shown.

Pull out the drawer and unscrew 2 screws.

Lift the side the Control Panel Assembly and pull it out

Unscrew the 10 screws from the Control Panel

Assembly.

Disassemble the Display PWB Assembly.

Push out PANEL ASSEMBLY,CONTROL after

Push the hook(®Á) below.

(1)

(1)

(2)

Rinse

Spin

Check during spin if the frequency of the water
level is 248 or more.

When pressing Rinse, Spin, and Power buttons
at the same time after power, press the
START/PAUSE button 2 times in QC Test mode,
is the drum spinning at low speed?

Is it disconnected, or disassembled?
[Red: 3pin (1), NA: 4pin (2)]

Resistance of terminal:

About 5Ω -15Ω

Check the motor connector, Is the resistance of
the terminal the same as the figure?
MOTOR TERMINAL

Replace the MAIN PWB ASSEMBLY

Does the spring of Latch Hook actuate?

Is there clicking sound once or twice when the
START/PAUSE button is pressed to start the cycle?

Is DOOR SWITCH ASSEMBLY broken?

Check the SENSOR SWITCH
ASSEMBLY or HOSE (Pressure).
If the problem is on the SENSOR
SWITCH ASSEMBLY or the
HOSE, replace the SENSOR
SWITCH ASSEMBLY or the
HOSE.

Normal

Correct the connection.

Replace the STATOR
ASSEMBLY

Replace Door Assembly.

Check the DOOR SWITCH
ASSEMBLY Connector and
MAIN PWB ASSEMBLY
(Red 3 pin, Yellow 4 pin and
white 3 pin connector (1)).

Replace the DOOR
SWITCH ASSEMBLY.