LG WD-D1217RD6 Service Manual ▷ View online
36
Open the door.
Unscrew the 7 screws from the HINGE COVER.
Put a flat ( - ) screwdriver into the openng of the hinge,
and pull out the hinge cover.
Unscrew a screw from the lower side of door.
Disassemble the door upward.
Open the door and disassemble the CLAMP
ASSEMBLY.
Unscrew the 2 screws.
Be careful! The door is heavy.
NOTE
• Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
37
Disassemble the cabinet cover.
Separate 2 connectors from the heater.
Loosen the nut and pull out the heater.
Disassemble the cabinet cover.
Separate the pump hose, the bellows
and the circulation hose assembly from the
pump assembly.
pump assembly.
Disassemble the pump assembly in arrow
direction.
CAUTION
• When assembling the heater, insert the
heater into the heater clip on the bottom of
the tub.
the tub.
• Tighten the fastening nut so the heater is
secure.
38
Unscrew the 4 screws from the back cover.
Unscrew the single screw from the lower-right
side of the cabinet.
Disconnect the connector from PWB Harness.
Disassemble the cabinet cover.
Separate the heater from the tub.
Remove any foreign objects (wire, coin, etc.) by
inserting a long bar in the opening.
39
Disassemble the damper hinges from the tub
and base.
Separate the dampers.
Unscrew the 2 screws from the tub bracket.
Remove the 6 bolts on the stator.
Unplug the 2 connectors from the stator.
Disassemble the back cover.
Remove the bolt.
Pull out the Rotor.
NOTE
• Once removed, replace the damper with
new one.
Click on the first or last page to see other WD-D1217RD6 service manuals if exist.