LG WD-80192N / WD-80192SV Service Manual ▷ View online
25
Disassemble the top plate assembly.
Pull out the drawer to arrow direction.
Unscrew 2 screws.
Disassemble hose and its clamps.
Disassemble ventilation bellows and water inlet
bellows on the tub.
Option
DISPENSOR ASSEMBLY
DRAWER
DISPENSER ASSEMBLY
26
Disconnect the wiring receptacle.
Unscrew 2 screws from the back.
When reconnecting the connector
Open the lower cover cap by using coin and pull out the
lower cover to the arrow direction after a screw is
unscrewed.
Open the door completely.
Remove the two screws from the hinge.
When removing the door assembly, it is necessary to
hold the bracket that is inner of the cabinet cover.
1
2
3
INLET VA LVE
LOWER COVER
VALVE #1 (MAIN)
White/Black-Black
VALVE #2 (PRE)
Black - Gray
VALVE #3 (HOT)
Blue/White - Black
DOOR
27
Take apart the cabinet gasket clamp.
Unscrew 2 screws from the cabinet cover.
Open the lower cover cap and unscrew 1 screw inside.
Take apart the lower cover.
Disassemble the cantrol panel. (refer to the page 25)
Unscrew all the screws on the upper and lower sides
of the cabinet cover.
Take apart the tub gasket clamp.
Make sure that the drain hole of the gasket is put
beneath when reassembling the gasket.
Refer to the arrow mark on the tub cover.
GASKET ASSEMBLY
28
Remove the back cover.
Take off the belt turning the pulley.
Unscrew the bolt to pull out the pulley.
Unscrew 2 screws from the bracket.
Push the motor in the arrow direction for
disassembling.
When reassembling the motor, make sure that motor
mounting bushings are not taken off from the bracket.
Pull out the hinge, pressing its snap.
Do not use the pulled - out hinge again. It may be
taken off during operation.
Hinge,
Damper
Damper
Damper
1
2
3
PULLEY, MOTOR, DAMPER
(PULLEY)
(MOTOR)
(DAMPER)
Open the lower cover cap (
) by
using a coin. Turn the drain plug
(
(
) to pull out the hose.
Unplug the drain plug (
) , then
the water flows out,
At this time use a vessel
To prevent water from flowing on
the floor. If the water does not flow
any more,turn the pump filter (
At this time use a vessel
To prevent water from flowing on
the floor. If the water does not flow
any more,turn the pump filter (
)
open to the left.
Take out any foreign material
from the pump filter (
from the pump filter (
). After
cleaning, turn the pump filter(
)
clockwise and insert the
drain plug (
drain plug (
)to the original
place. close the lower cover cap.
Clean the drain pump filter
1
100
2
3
2
3
Click on the first or last page to see other WD-80192N / WD-80192SV service manuals if exist.