LG WD-1485AD5 Service Manual ▷ View online
17
If you press the Start/Pause button in error condition, any error except
will disappear and the
machine will change into the pause status.
In case of
In case of
,
, if the error is not resolved within 20 sec., and in case of other errors,
if the error is not resolved within 4 min., power will be turned off automatically and the error only will be
blinked. But in the case of
blinked. But in the case of
, power will not be turned off.
7-5. ERROR DISPLAY
ERROR
SYMPTOM
CAUSE
WATER
I
NLET
E
RROR
• Not reached the water level(246) within 8 minutes
after water supplied or not reached to the preset
water level within 25 minutes.
water level within 25 minutes.
Page 23
1
U
NBALANCE
E
RROR
• The appliance is tilted.
• Laundry is gatherd to one side.
• Laundry is gatherd to one side.
Page 24
2
WATER
O
UTLET
E
RROR
• Not fully drained within 10 minutes.
Page 25
3
OVER
F
LOW
E
RROR
• Water is over flowing (over level 8).
If " " is displayed, the drain pump
operates to drain the water
automatically.
Page 27
4
P
RESSURE SENSOR
S/W
E
RROR
• The sensor pressure switch is out of order.
Page 28
5
D
OOR OPEN
E
RROR
• In case of operating the reservation function or the
other function with door opened. Close the door,
then the error display is resolved.
then the error display is resolved.
• The door switch is out of order.
Page 29
6
T
HERMISTOR(HEATING)
E
RROR
• The THERMISTOR is out of order.
Page 30
7
18
ERROR
SYMPTOM
CAUSE
MOTOR
L
OCKED
E
RROR
• The connector in the LEAD WIRE ASSEMBLY is
not connected to the connector of STATOR
ASSEMBLY.
ASSEMBLY.
Reconnect or repair the connector.
• The hall sensor is out of order/defective.
Replace the STATOR ASSEMBLY
Page 31
8
P
OWER
F
AILURE
• The washer experienced a power failure
press the start/pause button
9
D
RY
H
EATER
E
RROR
• The Dry Heater is out of order
• The Connector of the Dry Heater is not connected
• The Connector of the Dry Heater is not connected
properly to the cinnector in the Main PWB ASSEMBLY
• The Dry fan motor is out of order
Page 31
10
19
7-6. TROUBLESHOOTING WITH ERROR
Water Inlet Error (IE)
Is the water tap
closed?
[Note] Environmental safety check list
1. No water tap leakage & freeze.
2. No entanglement of water supply hose.
. e g a k a e l e s o h y l p p u s r e t a
w o
N . 4
. e g a t r o h s r e t a
w o
N . 3
5. No the inlet filter clogged.
Check
the
Water tap
and open it
fully.
When there is water in the tub,
is the water level frequency
over 26.2KHz?
is the water level frequency
over 26.2KHz?
Reconnect or repair
the
Connector
.
Or replace
the
Harness
.
Replace
the
Inlet Valve
.
Is the
Connector
connected correctly to the
Main
PCB
and the
Inlet Valve
?
Or is the
Harness
alright ?
Check
the
Air Chamber
and
the Tube
(clogged)
And When you check the water level frequency again,
if it is over 26.2KHz, you
if it is over 26.2KHz, you
replace
the Pressure switch.
YES
YES
NO
NO
Replace
the
Main PCB
.
NO
YES
YES
NO
NO
Is the each resistance of Inlet Valve within
3.5 ~4.5 kΩ ?
3.5 ~4.5 kΩ ?
When the washing machine is started,
is operated the inlet valve?
is operated the inlet valve?
Pre. Valve
Main Valve
Dry Valve
1
3
2
1
3
2
20
Unbalanced Error (UE)
Does the load lean toward
one
side, or is the load a few items?
Is the washing machine
installed
at an
angle?
Adjust the height of washing
machine to be kept
machine to be kept
horizontally.
( Page 7)
Is the laundry
mixed?
The few items of clothing will clump together
and their weight will be in one place on the drum,
throwing the weight off during spin mode.
So add some laundry to overcome UE error.
And rearrange load to allow proper spinning.
and their weight will be in one place on the drum,
throwing the weight off during spin mode.
So add some laundry to overcome UE error.
And rearrange load to allow proper spinning.
Try
rearranging the laundry in drum
Or the laundry is
separated by size, type, and color.
Separate by size,
type and color
YES
YES
NO
NO
YES
Click on the first or last page to see other WD-1485AD5 service manuals if exist.