LG WD-10344ND Service Manual ▷ View online
28
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the BODY FRAME.
(Only 1400 rpm models)
Note : Hook of connector (1) is on the backside
Pull out the hinge, pressing its snap.
Do not use the pulled out hinge again. It may be taken
off during operation.
Hinge,
Damper
Damper
Damper
(1)
Rotor
Bolt
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
(DAMPER)
Open the lower cover cap (
) by
using a coin Turn the drain plug
(
(
) to pull out the hose.
Unplug the drain plug (
) , then
the water flows out,
At this time use a vessel
to prevent water flowing on the
floor. If the water does not flow any
more,turn the pump filter (
At this time use a vessel
to prevent water flowing on the
floor. If the water does not flow any
more,turn the pump filter (
)
open to the left.
Take out any foreign material
from the pump filter (
from the pump filter (
). After
cleaning, turn the pump filter(
)
clockwise and insert the
drain plug (
drain plug (
) to the original
place. close the lower cover cap.
Clean the drain pump filter
1
100
2
3
2
3
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
29
Pump Outlet Hose
Tub Pump
Bellows
Bellows
Remove pump outlet hose.
Remove tub pump bellows.
Remove cap (Remaining Hose.)
Disconnect the wiring.
Unscrew 2 screws.
Remove the pump.
Loosen the M6 heater nut to pull out the heater.
When mounting the heater, be sure to insert the heater
into the heater clip on the bottom of the tub.
Pull it out by holding the thermistor bracket.
If it is pulled by the wire, it may be broken.
When mounting the thermistor again, make sure that it
is got back tight to the bushing.
PUMP
HEATER
THERMISTOR
CAUTION
30
SWITCH ASSEMBLY, DOOR LOCK
WHEN FOREIGN MATERIAL IS STUCK BETWEEN DRUM AND TUB
Take apart the cabinet cover clamp and release
the gasket.
Unscrew 2 screws holding the door lock.
Disconnect the door lock from the wiring connector.
Remove the heater.
Remove the foreign material (wire, coin and others) by
inserting a long bar through the hole.
10-1.THE EXPLODED VIEW OF CABINET ASSEMBLY
31
10. EXPLODED VIEW
A150
A141
A131
A134
A133
A276
A275
A277
A310
A220
A440
A410
A485
A430
A100
A101
A110
A102
A104
A103
A300
A303
A130
A140
A154
A151
A152
A153
A273
A274
A271
A272
A270
Click on the first or last page to see other WD-10344ND service manuals if exist.