LG WD-10121TD Service Manual ▷ View online
25
Disassemble the top plate assembly.
Pull out the drawer to arrow direction.
Unscrew 2 screws.
The hose clamps and the hose are disassembled.
The ventilation bellows and the water inlet bellows are
disassembled on the tub.
Option
DISPENSER ASSEMBLY
DISPENSER ASSEMBLY
26
Disconnect the wiring receptacle.
Unscrew 2(4) screws from the back.
When reconnecting the connector
Open the lower cover cap by using coin and pull out the
lower cover to the arrow direction after a screw is
unscrewed.
Open the door completely.
Remove the two screws from the hinge.
When removing the door assembly, it is necessary to
hold the bracket that is inner of the cabinet cover.
INLET VALVE
LOWER COVER
VALVE #1 (MAIN)
White / Black - Black
VALVE #2 (PRE)
Gray / White - Black
VALVE #3 (HOT)
Blue / Red - Black
DOOR
27
Take apart the cabinet gasket clamp.
Unscrew 2 screws from the cabinet cover.
Open the lower cover cap and unscrew 1 screw inside.
Take apart the lower cover.
Disassemble the control panel. (page 24)
Unscrew all the screws on the upper and lower sides
of the cabinet cover.
GASKET ASSEMBLY
Take apart the tub gasket clamp.
Make sure that the drain hole of the gasket is put
beneath when reassembling the gasket.
Refer to the arrow mark on the tub cover.
28
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the STATOR.
Note : Hook of connector (1) is on the backside
Pull out the hinge, pressing its snap.
Do not use the pulled-out hinge again. It may be taken
off during operation.
Hinge,
Damper
Damper
Damper
(1)
Rotor
Bolt
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
(DAMPER)
Open the lower cover cap (
) by
using a coin. Turn the drain plug
(
(
) to pull out the hose.
Unplug the drain plug (
) , then
the water flows out,
At this time use a vessel
to prevent water from flowing on the
floor. If the water does not flow any
more, turn the pump filter (
At this time use a vessel
to prevent water from flowing on the
floor. If the water does not flow any
more, turn the pump filter (
)
open to the left.
Take out any foreign material
from the pump filter (
from the pump filter (
). After
cleaning, turn the pump filter(
)
clockwise and insert the
drain plug (
drain plug (
) to the original
place. close the lower cover cap.
Clean the drain pump filter
1
100
2
3
2
3
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
Click on the first or last page to see other WD-10121TD service manuals if exist.