LG TCW2013QS Service Manual ▷ View online
3 6
7. Tilt the CABINET COVER.
8 . Disconnect the DOOR S/W connector.
8 . Disconnect the DOOR S/W connector.
આ
NOTE: When assemblingthe CABINET
COVER, connect the connector.
9. Lift and separate the CABINET COVER.
1. Disassemble the CABINET COVER
(refer to page 35).
2. Disassemble the CLAMP ASSEMBLY.
3. Disassemble the GASKET.
3. Disassemble the GASKET.
TUB GASKET
CLAMP
CLAMP
/);3-<
37
1. Open the DOOR.
2. Unscrew the 7 screws from the HINGE COVER.
2. Unscrew the 7 screws from the HINGE COVER.
3. Put a flat ( - ) screwdriver into the openng of the hinge, and
pull out the HINGE COVER.
4. Unscrew a screw from the lower side of DOOR.
5. Lift door and remove.
5. Lift door and remove.
HINGE COVER
1. Open the DOOR and disassemble the CLAMP
ASSEMBLY.
2. Unscrew the 2 screws.
3. Remove connector from DOOR S/W ASSEMBLY.
3. Remove connector from DOOR S/W ASSEMBLY.
DOOR SWITCH
ASSEMBLY
CLAMP
ASSEMBLY
આ
Be careful! The door is heavy.
આ
NOTE
Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
38
pump );;-5*4A
heater
1. Disassemble the CABINET COVER
(refer to page 35).
2.
Separate the PUMP HOSE and the BELLOWS
from the PUMP ASSEMBLY.
3. Unscrew 2 screws.
4.
4.
Remove the PUMP ASSEMBLY in arrow
direction.
1. Disassemble the CONTROL PANEL ASSEMBLY
(refer to page 31).
2. Disassemble the TOP PLATE ASSEMBLY
(refer to page 32).
3. Disassemble two (or three) connectors from
the NOISE FILTER.
4. Unscrew a screw from the TOP BRACKET.
NOISE FILTER
1.
Disassemble the cabinet cover.
2.
Separate 2 connectors from the heater.
3.
Loosen the nut and pull out the heater.
CAUTION
When assembling the heater, insert the
heater into the heater clip on the bottom of
the tub.
Tighten the fastening nut so the heater is
secure.
39
motor );;-5*4A
damper
!"
!"
#!
! $
%
&
!
&
'( !
#!
)* !
+
'! (
#!
+
'! +
'!
આ
NOTE
, !-
+ +
'! ' ".
!' " "
Click on the first or last page to see other TCW2013QS service manuals if exist.