LG F1443KDS2 / F1443KDS27 Service Manual ▷ View online
57
REAR COVER ASSEMBLY
2 Remove screws that fasten the rear cover
to the side cabinets.
1
3 Remove screws that fasten the rear cover
to the base cabinet.
4 Remove screws that fasten the rear cover
to the tub outer.
5 Remove screws that fasten the drain hose
holders to the rear cover.
6 Remove screws that fasten the inlet valve
assembly and the generator assembly to
the rear cover.
the rear cover.
7 Remove 2 earth screws from rear cover.
8 Disassembly 3 holder hooks for fixing
harness.
9 Disassemble the red connector assembled
noise filter.
10 Pull out drain hose from the rear cover.
11 Disassemble back cover.
Disassemble top plate assembly.
Needed tool : (+) Electric driver
58
REAR GASKET
Disassemble top plate assembly.
Needed tools :12,13 mm wrench, (
) Clamp Jig, Cable Tie, (+) Electric driver
Disassemble rear cover.
Remove large and small gasket clamps using
gasket clamp jig.
gasket clamp jig.
Unfasten the nut that fastens the rear
suspension to the base.
suspension to the base.
Unfasten the bolt that fastens the rear
suspension to the bearing housing.
suspension to the bearing housing.
Disassemble rear suspension.
Remove 8 screws from both weights.
Disassemble rear gasket.
1
2
3
4
5
6
7
8
59
FRONT GASKET
Disassemble top plate assembly.
Needed tools : (
) Clamp Jig, (+) Electric driver
Disassemble control panel assembly.
Disassemble lower cover assembly.
Disassemble cabinet cover assembly.
Disassemble front gasket clamp using clamp
jig.
jig.
6
Take out gasket hole parts from the hook
of tub cover (Direction of 11:00, 9:00,
7:00, 6:00, 5:00, 3:00 and 1:00 o’clock ).
of tub cover (Direction of 11:00, 9:00,
7:00, 6:00, 5:00, 3:00 and 1:00 o’clock ).
7
Take out upper part of the front gasket
from the dry duct hole of the tub cover.
from the dry duct hole of the tub cover.
8
Disassemble front gasket.
1
2
3
4
5
60
FRICTION DAMPER ASSEMBLY (RIGHT SIDE)
Disassemble the right side cabinet.
Needed tools : Damper pin Jig, long nose, (+) Electric driver
Remove 2 damper holders from the tub
bracket and the base holder.
bracket and the base holder.
Disassemble friction damper assembly.
SUSPENSION ASSEMBLY (RIGHT SIDE)
The right side cabinet is disassembled.
Needed tools :12,13 mm wrench, (+) Electric driver
Disassemble nut, (Suspension – Base
Cabinet)
Cabinet)
Remove suspension bolt.
Disassemble suspension assembly.
1
2
3
1
2
3
4
Click on the first or last page to see other F1443KDS2 / F1443KDS27 service manuals if exist.