LG F1443KDS2 / F1443KDS27 Service Manual ▷ View online
53
1
2
1 Unfasten the screws from the cabinet cover
assembly.
3 Disconnect the locker switch assembly from the
multi harness.
2 Disassemble the cabinet cover assembly.
NOTE: When assembling the cabinet
cover assembly, connect the multi harness
to the door switch assembly.
cover assembly, connect the multi harness
to the door switch assembly.
LOCKER SWITCH ASSEMBLY
10 Disassemble the cabinet cover assembly by
pulling the lower part of the cabinet cover
assembly first and then lift it up.
assembly first and then lift it up.
54
• V ~ U (8~11Ω)
• U ~ W (8~11Ω)
• W ~ V (8~11Ω)
• U ~ W (8~11Ω)
• W ~ V (8~11Ω)
Motor Stator
U V W
Hall Sensor
Ha
Hb
Common
• Common ~ Ha (5~15kΩ)
• Common ~ Hb (5~15kΩ)
• Common ~ Hb (5~15kΩ)
1 Remove the housing coupled the AG
(Connector, Hoses, Earth Screw)
2 Take out the screw of the AG.
1 Remove the rear cover.
2 After loosening the bolt, pull out the rotor.
1 Remove the 6 bolts from the stator.
2 Disconnect the 2 connectors.
2 Disconnect the 2 connectors.
AG (ALPHA GENERATOR) (OPTION)
ROTOR ASSEMBLY, STATOR ASSEMBLY
< Heater for STEAM>
• Rating : 230V 1100W
• Resistant : 42.5~49.5Ω
• Rating : 230V 1100W
• Resistant : 42.5~49.5Ω
55
1 Disassemble the lower cover assembly.
2 Take out the main PCB assembly from the
front of the washer.
3 Remove 3 clamps from the each hose.
4 Remove 3 screws from the base cabinet.
5 Disconnect the wire of pump.
6 Take out the drain pump assembly in the
direction displayed in the fig.
1 Loosen the nut.
2 Remove washing heater by pulling out.
2 Remove washing heater by pulling out.
When assembling the washing heater, insert
the heater to heater clip on the bottom of tub
and check the position of wire color.
the heater to heater clip on the bottom of tub
and check the position of wire color.
DRAIN PUMP ASSEMBLY
HEATER
< Heater for Washing>
• Rating : 230V 2000W
• Resistant : 24.5~28.5Ω
• Rating : 230V 2000W
• Resistant : 24.5~28.5Ω
CAUTION
56
1 Remove washing heater.
2 Remove the foreign object(wire,coin,etc) by
2 Remove the foreign object(wire,coin,etc) by
inserting long bar in the hole.
WHEN FOREIGN OBJECT STUCK BETWEEN DRUM AND TUB
1 Disassemble lower cover assembly.
2 Disassemble MAIN PWB ASSEMBLY
3 Disconnect the wiring connector.
4 Unfasten the screw from the part displayed in
the fig and then turn the safety switch assembly
to disassemble.
to disassemble.
SAFETY SWITCH ASSEMBLY
2
1
Click on the first or last page to see other F1443KDS2 / F1443KDS27 service manuals if exist.