DOWNLOAD LG F1091QDTA Service Manual ↓ Size: 18.92 MB | Pages: 45 in PDF or view online for FREE

16

Program Chart

Blanket

Bulky

Spin

Boiling Care

Cotton Quick

2

40

1:10

1

45

16

2:36

1:21

1:32

1:15

15

Before servicing ask the customer what the trouble is.
Check the adjustments. (Power supply :220-240V~, Removal of tra nsit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works  OK or NOT.

7. TROUBLESHOOTING

7-1. BEFORE PERFORMING SERVICE

7-2. LOAD TEST MODE

1 F1091Q/T D(T/P)2(A)(0~9) : Press and Hold ‘

’ & ‘

’ buttons and then press ‘

’ button.

7-3. HOW TO KNOW THE WATER LEVEL FREQUENCY

Press and Hold ‘ Spin ’ & ‘ Pre Wash ’ buttons simultaneously.

2 The washer must be empty and the controls must be in the off state.
3 Press Power with above two buttons pressed and then buzzer will  sound.
4 Press the Start/Pause button repeatedly to cycle through the te st modes

1
2
3
4
5
6

None 

1 time 

2 times 
3 times 

4 times 

5 times 

6 times 
7 times 
8 times 
9 times 

10 times 

All lamps turn on
Clockwise 

wash (right) 

Low speed Spin 
High speed Spin

Inlet valve for pre-wash operation

Inlet valve for main-wash operation

Hot inlet valve in case of hot water fill
Counterclockwise wash (left) 
A Heater is in operation for 3 sec.
Draining pump operation 

Auto off operation

Motor rpm (About 47)
Motor rpm (About 590~650)

Motor rpm (About 950~1050) :F8091Q/T D(T/P)2(A)(0~9)

Motor rpm (About 1100~1250) :F10/1291Q/T D(T/P)2(A)(0~9)
Motor rpm (About 1100~1250) :F1491Q/T D(T/P)2(A)(0~9)

 
Water level frequency (255->299)

Water level frequency (255->299)

Water level frequency (255->299)
Motor rpm (About 47)
Water Temperature
Water level frequency

The digits means water level frequency (10

-1

kHz)

ex) 241 : Water level frequency = 241 X 10

-1

kHz

= 24.1kHz

7-4. ERROR DISPLAY

• Load is too small.

• Load is out of balance.

• The appliance has an imbalance detection

and correction system. If individual heavy

articles are loaded (ex. bath mat, bath robe,

etc.) this system may stop spinning or even

interrupt the spin cycle altogether.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry to

balance the load and repeat the spin cycle.

• Water supply is not adequate in area.

• Water supply taps are not completely open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are clogged.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose.

Clean and straighten the drain hose.

Clean the drain filter.

Add 1 or 2 similar items to help 

balance the load.

Rearrange load to allow proper 

spinning

Close the door.

If it is not released, call for service.

Unplug the power plug and call for 

service.

Close the water tap.

Unplug the power plug.

Call for service.

• Drain hose is kinked or clogged.

• The drain filter is clogged.

• Is the door opened?

• Water overfills due to the faulty water valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• Over load in motor.

7-5. TROUBLESHOOTING WITH ERROR

Water Inlet Error (IE)

Is the water tap closed ?

[Note] Environmental safety check list

1. No water tap leakage & freeze.

2. No entanglement of water supply hose.

5. No the inlet filter clogged.

Check the 

Water tap

and  open it fully .

When there is water in the tub,
is the water level frequency
over 25.5KHz ?

Reconnect or repair the 

Connector

.

Or replace the 

Harness

.

Replace the 

Inlet Valve

.

Is the 

Connector

connected correctly to 

the 

Main PCB

and the 

Inlet Valve

?

Or is the 

Harness

alright ?

Check the 

Air Chamber

and 

the Tube

(clogged) 

And When you check the water level frequency again, 
if it is over 25.5KHz, you replace 

the Pressure switch.

YES

YES

NO

NO

Replace the 

Main PCB

.

NO

YES

YES

NO

NO

Is the each resistance of Inlet Valve within
3.5 ~4.5 kΩ ?

When the washing machine is started, 
is operated the inlet valve? 

Pre. Valve

Main Valve

19

1

2

1

2

3. No water shortage.                           4. No water supply hose leakage