DOWNLOAD LG F1069FD6S Service Manual ↓ Size: 6.04 MB | Pages: 44 in PDF or view online for FREE

8-5. ERROR DISPLAY

If you press the START button when an error is displayed, any error except      will disappear and the 
machine will go into the pause status.

WATER INLET

ERROR

• Correct water level (246) is not reached within 10 minutes

after water is supplied or it does not reach the preset water
level within 12 minutes.

• The load is too small.
• The appliance is tilted.
• Laundry is gathered to one side.
• Non distributable things are put into the drum.

• Not fully drained within 3 minutes.

• Water is overflowing (water level frequency is over 213).

If               is displayed, the drain pump will operate to
drain the water automatically.

• The SENSOR SWITCH ASSEMBLY is out of order.

• Door not all the way closed. 
• Loose electrical connections at door switch and

PWB Assembly.

• The DOOR SWITCH ASSEMBLY is out of order.

IMBALANCE

ERROR

DRAIN

ERROR

OVER FLOW

ERROR

DOOR OPEN

ERROR

PRESSURE

SENSOR

ERROR

The connector (3-pin, male, white) in the MOTOR

HARNESS is not connected to the connector

(3-pin, female, white) of STATOR ASSEMBLY.
The electric contact between the connectors

(3-pin, male, white) in the MOTOR HARNESS

and 4-pin, female, white connector in the MAIN PWB

ASSEMBLY is bad or unstable.
The MOTOR HARNESS between the STATOR

ASSEMBLY and MAIN PWB ASSEMBLY is cut (open

circuit).

The hall sensor is out of order/defective.

LOCKED

MOTOR

ERROR

Disconnection of Card Reader Wire.

CARD

READER

ERRER

EEPROM is out of order.

Displayed only when the START button is first pressed

in the QC Test Mode.

EEPROM

ERROR

8-6. DISPENSER

The dispenser drawer is a multi-chambered reservoir that allows the user to add all the appropriate
laundry additives before starting the cycle. It has a place for pre-wash and Main wash detergent, fabric
softener, and bleach. Powdered or liquid detergents may be used, but softener and bleach must be
liquids.
Detergents should carry the HE designation. Do not use regular detergents in the washer or overusing
will occur. Regular detergents also cause a scum build-up in the tub, which leads to poor performance
and a foul odor.

HOT INPUT

MAIN WASH

BLEACH

SOFTNER

1

2

3

4

1

2

3

4

1
2

3

4

9

. DIAGNOSIS AND TROUBLESHOOTING

1. Be careful of electric shock if disconnecting parts while troubleshooting.

2. First, check the connection of each electrical terminal with the wiring diagram.

3. If you replace the MAIN PWB ASSEMBLY, reinsert the connectors correctly.

Is the supplied voltage AC 220 - 240 V, 50 Hz?

Is the voltage between the FILTER ASSEMBLY
connectors 

and 

AC 220 - 240 V, 50 Hz

Is the LED lamp 

on?

Are the connectors 

on the PWB loose?

Is wire of the DISPLAY PWB ASSEMBLY  
broken?

Replace  DISPLAY PWB ASSEMBLY 
or repair wire.

Check the fuse or reset
the circuit breaker.

Replace the FILTER
ASSEMBLY (CIRC).

Replace MAIN PWB
ASSEMBLY.

Reconnect.

Replace the CABLE
(HARNESS)