LG F1069FD3S Service Manual ▷ View online
12
Electrical connection
WARNING! Concerning the power cord
Do not use an extension cord or double adapter.
If the supply cord is damaged, it must be replaced by a qualified person in order to avoid a hazard.
If the machine will not be used for an extended time, unplug it, shut off the water supply and open the door to
provide ventilation.
Connect the machine to a grounded outlet in accordance with current wiring regulations.
The appliance must be positioned so that the plug is easily accessible.
Water supply pressure must be between
14.5 and 116 psi (100~800 kPa).
Do not crossthread when connecting the inlet hose
to the valve.
to the valve.
If the water supply pressure is more than 116 PSI,
a pressure reducing device should be installed.
a pressure reducing device should be installed.
Two sealing washers are supplied with the water
inlet hoses to prevent water leaks.
inlet hoses to prevent water leaks.
Check for leakage of washing machine connections
by turning the tap completely on.
by turning the tap completely on.
Periodically check the condition of the hose and
replace the hose if necessary.
replace the hose if necessary.
Make sure that there is no kink in the hose and that
it is not crushed.
it is not crushed.
Be sure that the two water input ports are connected
to the correct water faucets. The connector for hot
water is colored red; the cold is blue.
to the correct water faucets. The connector for hot
water is colored red; the cold is blue.
Connecting the water supply hoses
Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that
appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be
certain.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords,
or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire.
Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it,
discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer.
appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be
certain.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords,
or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire.
Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it,
discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer.
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or
walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.
walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.
NOTE: Use new hoses when installing a washing machine. Replace them periodically.
Old hoses should not be used.
Do not install your washing machine in a room where temperatures below freezing may occur.
Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired
at temperatures below the freezing point.
Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired
at temperatures below the freezing point.
If the appliance is delivered in the winter months and temperatures are below freezing,
store the washing machine at room temperature for a few hours before putting it into operation.
store the washing machine at room temperature for a few hours before putting it into operation.
13
Installation of drain hose
about 45"(1.1m)
about 70"(1.8m)
max 39"(1.0m)
min 24"(0.6m)
about 45"(1.1m)
about 70"(1.8m)
max 39"(1.0m)
min 24"(0.6m)
(2.4 m)
• Place the end of the drain hose in the hole of the
floor drain system.
• When installing the drain hose at a sink, secure it so it
cannot break away and cause flooding and damage.
• The drain hose should not be placed higher than
96 in. from the bottom of the washer.
• Properly securing the drain hose will protect the floor
from damage due to water leakage.
• Properly securing the drain hose will protect the
floor from damage due to water leakage.
Make sure that the hose is not twisted.
Do not submerge the end of the hose.
14
OPL TYPE
- SIDE BY SIDE (F1069FD3S)
OPTIONAL FUNCTION BUTTON
1. DISPLAY LED
4. START BUTTON
2. CYCLE BUTTON
5. STATUS LED
3. OPTIONAL CYCLE BUTTON
6. OPERATION
LED flashes whenever the washing
cycle is in operation.
cycle is in operation.
LED flashes whenever the Rinsing
cycle is in operation.
cycle is in operation.
LED flashes whenever the Spining
cycle is in operation.
cycle is in operation.
LED flashes whenever the door lock
is activated.
is activated.
15
DISPLAY LED
CYCLE BUTTON
STATUS LED
The display shows the vend price and remaining time
and programming options. Error codes are also
displayed here.
and programming options. Error codes are also
displayed here.
START BUTTON
OPTIONAL FUNCTION BUTTON
DISPLAY LED
1
RINSE+SPIN
Rinse,drain and spin only
Use this cycle to rinse detergent form load
Rinse,drain and spin only
Use this cycle to rinse detergent form load
OPTIONAL FUNCTION BUTTON
3
The START LED flashes when the full vend price
has been satisfied and the cycle has been chosen.
has been satisfied and the cycle has been chosen.
START BUTTON
4
STATUS LED
5
Press the CYCLE button to select the desired cycle
based on laundry types and conditions.
based on laundry types and conditions.
Use it for the more medical wash than 75°C HOT
such as white clothes, baby clothes, sheets and
underwear.
such as white clothes, baby clothes, sheets and
underwear.
CYCLE BUTTON
90°C MEDICAL
Use it for heavy soiled fabrics such as white
clothes, baby clothes, sheet and underwear.
clothes, baby clothes, sheet and underwear.
75°C HOT
Use it for heavy soiled fabrics such as baby wear,
underwear and white clothes.
underwear and white clothes.
60°C NORMAL
Use it for normal soiled fabrics such as cotton,
linen, towels, shirts and jeans.
linen, towels, shirts and jeans.
40°C NORMAL
2
Click on the first or last page to see other F1069FD3S service manuals if exist.