DOWNLOAD LG F1022ND Service Manual ↓ Size: 7.49 MB | Pages: 36 in PDF or view online for FREE

7-4. ERROR DISPLAY

If you press the [Start/Pause] button when an error in displayed, any error except S/W ERROR will
disappear and the machine will change into pause status.
In case of        ,        ,        , if the error is not resolved within 15 sec. In case of other errors, if the
error is not resolved within 4 min. Power will be turned off automatically and the error only will be
blinked. But in the case of       , power will not be turned off.

WATER INLET

ERROR

Water has not reached to the pre-set level within 4 min.
since inlet valve operated, or water has not reached to
the normal level within 25 min.

1

IMBALANCE 

ERROR

2

DRAIN ERROR

3

OVERFLOW 

ERROR

4

The appliance is tilted.

Laundry is gathered to one side.

Non distributable things are put into the drum.

Water has not drained enough within 8 min.

Water is automatically being pumped out because too
much water is in the tub.

SENSOR PRESSURE

S/W ERROR

5

The sensor pressure switch is out of order.

DOOR OPEN 

ERROR

6

The [Start/Pause] button is pressed with the door open.

The door switch is out of order.

HEATING 

ERROR

7

The thermistor is out of order.

POWER

FAILURE

10

The washer experienced a power failure.

CURRENT

ERROR

8

PWB ASSEMBLY (Main) is out of order

☞ Replace the PWB assembly (Main)
Winding in the MOTOR is short-circuited.
☞ Replace the MOTOR

LOCK 

ERROR

9

The Connector (3-pin, male, white) in the wire harness
is not connected to the Connector (3-pin, female, white)
of MOTOR.

☞ Reconnect or repair the connector
The electric contact between the connectors [3-pin,
male, white in the wire harness and 6-pin, female, white
in the PWB ASSEMBLY (Main]) is bad or unstable.
☞ Reconnect or repair the contact in the connector
The wire harness between the MOTOR and PWB
ASSEMBLY (Main) is cut (open circuited).
The hall sensor is out of order/defective.

8. ERROR DIAGNOSIS AND CHECK LIST

8-1. DIAGNOSIS AND ANSWER FOR ABNORMAL OPERATION

NO POWER

Water inlet trouble

Is the power plug connected firmly to

220-240V~ outlet?

Power failure? or Breaker opened?

Is the outlet controlled by a switch.

Is          displayed?

Is the tap opened?

Is the tap frozen?

Is the water supply shut-off?

Visit to check

Is filter in the inlet valve

clogged with foreign material?

Clean the filter of

inlet valve

Visit to check

° DOOR DOES NOT OPEN

Refer to

7-4 ERROR DISPLAY

° Drain Trouble

Did you press the Start/Pause button

when the door is open?

Close the door.

Is          displayed?

Is the debris filter clogged with foreign

material such as pins, coins, etc.?

Is the drain hose frozen with water,

kinked or crushed?

Visit to check.

Clean up

the filter.

Visit to check

° Suds overflow from the

appliance.

(In this condition, wash

and spin do not operate

normally)

° No effect of softener

Is low-sudsing detergent for the durm

washing machine used?

LOW SUDSING

DETERGENT

Is the proper amount of detergent used

as recommended?

Is softener put in the correct

compartment of drawer?

Is the drawer closed during wash?

Is the softener cap clogged?

Visit to check.

Explain how to use softener

Compartment for

softener

Recommend to reduce the amount
of detergent.

This appliance has the automatic suds sensing function which

operates under much suds condition for good rinse and

preventing overflow.

When much suds are sensed, the suds removing function such

as drain, water input, and pause will operate without rotating the

drum.