LG 29478 Service Manual ▷ View online
25
9) Disassembly of Rotor and Stator
① Use a wrench (M24) to remove the nut that
connects the rotor to the shaft.
(The torque should be 200 kgf/cm or 88 foot-
pounds.)
(The torque should be 200 kgf/cm or 88 foot-
pounds.)
② Remove the rotor by pulling it straight off the splined
shaft.
8) Disassembly of Damper Assembly
① Remove the top cover of the washing machine.
② As shown in the drawing, lift the damper
② As shown in the drawing, lift the damper
assembly and remove it along with the outer tub
assembly.
assembly.
③ Damper assembly shall not be disassembled.
Replace damper as assembly.
7) Disassembly of the Back Cover and
Drain Pump
① Remove the screws that attach the back cover and
take it off.
② Disconnect the leads and the drain hose from the
drain pump.
③ Remove the pump attachment screws and the lead
connector. Take the pump assembly out of the
washer.
washer.
④ Disconnect the hall sensor and stator
connection before removing the stator in the
subsequent step.
subsequent step.
26
⑤ Remove the six screws securing the rotor.
⑥ Check the position of the snap ring, being cure it
⑥ Check the position of the snap ring, being cure it
faces the rotor and stator.
⑦ To keep from dropping the stator, loosen the six
bolts almost all the way; then hold the stator in one
hand while removing the bolts with the other.
hand while removing the bolts with the other.
⑧ Be careful during removal and replacement to avoid
cutting, nicking, or pinching any of the wires. This
could cause a short or electrical noise in the
machine.
could cause a short or electrical noise in the
machine.
③ Remove the screws that secure the water guide.
27
9) Disassembly of Door Lock Switch
①
Remove the two door lock attachment screws.
②
Remove the door switch and remove the attachment tube.
10) Disassembly of Heater
① Remove the three heater attachment screws.
② Loosen the nut at the middle of the heater to relieve
② Loosen the nut at the middle of the heater to relieve
the tension on the clamp. Then pull it out of the case.
⑩ Remove 17 screws to release the bearing
housing. Pull the housing away from the tub, but
do not pry it with a screwdriver to avoid
damage.
do not pry it with a screwdriver to avoid
damage.
⑨ Remove four screws to release the tub bracket.
Bearing Housing
4-2. WIRING DIAGRAM
28
WIRING DIAGRAM
Heater
BLANCO
LETRAS
LETRAS
CÓDIGO DE COLORES
NEGRO
MARRÓN
NARANJA
ROSA
AZUL
ROJO
GRIS
VERDE
VIOLET
A
AMARILLO
AZUL
CIELO
Click on the first or last page to see other 29478 service manuals if exist.