MC-807SLR — LG Microwave Oven Service Manual (repair manual)

Model
MC-807SLR
Pages
39
Size
1.52 MB
Type
PDF
Document
Service Manual
Brand
Device
Microwave Oven
File
mc-807slr.zip
Date

View LG MC-807SLR Service Manual online

MICROWAVE OVEN
SERVICE MANUAL
MODEL: MC-807GLR/MC-807SLR
CAUTION
BEFORE SERVICING THE UNIT, READ THE
SAFETY PRECAUTIONS IN THIS  MANUAL.
• As the door is closed, the contact of MONITOR
SWITCH opens. This switch creates the short circuit to
blow 10 A fuse during operation under abnormal
condition.(ie, should the contacts of primary fail to open
the circuit)
• The latches are secured by latch board. The oven light
turns on while the oven is in operation.
WHEN COOKING POWER LEVEL AND
COOKING TIME ARE SET
• The contacts of the primary switch and the secondary
switch close the circuit.
• 230V A.C. is applied to the high voltage transformer
through power control switch as shown by the solid
line.
• Turntable and circulation motor rotate.
• The fan motor rotates and cools the magnetron by
blowing the air (coming from the intake on the
backplate) over the magnetron.
• The air is also directed into the oven to exhaust the
vapor in the oven through the base plate and back
plate.
• 3.5V A.C. is generated from the filament winding of the
high voltage transformer. This 3.5V is applied to the
magnetron to heat the magnetron filament through two
noise preventing choke coils. A high voltage of
approximately 2100V A.C. is generated in the
secondary of the high voltage transformer which is
increased by the action of the diode and charging of
the high voltage capacitor. The negative D.C. voltage is
then applied to the filament of the magnetron.
WHEN THE DOOR IS OPEN DURING
COOKING
• Both primary switch and secondary switch open to cut
off the primary winding voltage to the high voltage
transformer to stop microwave oscillation.
• Turntable and fan motor stop.
• As the door is opened, if the contact of primary switch
and relay 2 and/or secondary switch fail to open, the
10A fuse opens due to the large current surge caused
by the monitor switch activation which in turn stops
magnetron, oscillation.
WHEN TOUCHING THE START KEY
WITH THE CONVECTION/GRILL 
COOKING FUNCTION SELECTED.
• The contacts of the primary switch and the secondary
switch close the circuit.
• 230V A.C. is applied to the grill heater through grill
thermostat as shown by the solid line.
• Turntable rotate.
• The fan motor and circulation motor rotate.
• The air is also directed into the oven to exhaust the
vapor in the oven through the base plate and back
plate.
Circuit Description
4-4
FUSE
10A
PRIMARY
SWITCH
N
L
RELAY 2
H.V.T
MONITOR
SWITCH
FUSE
10A
PRIMARY
SWITCH
N
L
RELAY 2
H.V.T
MONITOR
SWITCH
CONVECTION
HEATER
RELAY 4
L
N
E
N
L
G-Y
RELAY 3
GRILL
HEATER
OVEN THERMOSTAT
L
N
E
N
L
G-Y
RELAY 3
GRILL
HEATER
OVEN THERMOSTAT
This device is to be serviced only by properly qualified service personnel.
Consult the Service Manual for proper service procedures to assure continued safety operation and for precautions to
be taken to avoid possible exposure to excessive microwave energy.
SAFETY PRECAUTIONS
PRECAUTIONS TO BE OBSERVED
BEFORE AND DURING SERVICING TO
AVOID POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
A) Do not operate or allow the oven to be operated with the door open.
B) Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs as necessary; (1) Interlock operation, (2) proper door closing, 
(3) seal and sealing surfaces (arcing, wear, and other damage), (4) damage to or loosening of hinges 
and latches, (5) evidence of dropping or abuse.
C) Before turning on microwave power for any service test or inspection within the microwave generating
compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment,
integrity, and connections.
D) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and
transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before
the oven is released to the owner.
E) A microwave leakage check should be performed on each oven prior to release to the owner.
CAUTION 
MICROWAVE RADIATION
DO NOT BECOME EXPOSED TO RADIATION FROM THE MICROWAVE
GENERATOR OR OTHER PARTS CONDUCTING MICROWAVE ENERGY.
TABLE OF CONTENTS
(Page)
SAFETY PRECAUTIONS ................................................................................................. Inside front cover
SPECIFICATIONS ......................................................................................................................................1-1
CAUTIONS ................................................................................................................................................ 2-1
INSTALLATIONS ....................................................................................................................................... 3-1
OPERATING INSTRUCTIONS .................................................................................................................. 4-1
FEATURES ........................................................................................................................................... 4-1
CONTROL PANEL .................................................................................................................................4-1
OPERATING SEQUENCE .................................................................................................................... 4-2
SCHEMATIC DIAGRAM  ....................................................................................................................... 4-3
CIRCUIT DESCRIPTION ...................................................................................................................... 4-4
SERVICE INFORMATION ......................................................................................................................... 5-1
TOOLS AND MEASURING INSTRUMENTS ........................................................................................ 5-1
MICROWAVE LEAKAGE TEST  ............................................................................................................ 5-1
MEASUREMENT OF MICROWAVE POWER OUTPUT ....................................................................... 5-3
DISASSEMBLY AND ADJUSTMENT .....................................................................................................5-3
INTERLOCK CONTINUITY TEST  ........................................................................................................ 5-8
COMPONENT TEST PROCEDURE ..................................................................................................... 5-9
TROUBLE SHOOTING GUIDE ........................................................................................................... 5-14
EXPLODED VIEW ..................................................................................................................................... 6-1
REPLACEMENT PARTS LIST  .................................................................................................................. 7-1
SCHEMATIC DIAGRAM OF P.C.B. ........................................................................................................... 8-1
PRINTED CIRCUIT BOARD................................................................................................................. 8-2
PCB PARTS LIST....................................................................................................................................... 9-1
Page of 39
Display

Download LG MC-807SLR Service Manual (Repair Manual)

Here you can view online or download LG MC-807SLR Service Manual in pdf. This Service Manual can help you recover, restore, fix, disassemble and repair LG MC-807SLR Microwave Oven. Information contained in LG MC-807SLR service manual (repair manual) typically includes:

  • Disassembly, troubleshooting, programming, maintenance, remote, adjustment, installation and setup instructions.
  • Schematics, wiring and block diagrams.
  • Printed wiring boards (PWB) and printed circuit boards (PCB).
  • Parts list (bill of materials).