LG LS-H126RLN1 / LS-H096QLN1 / LS-H076QLN0 / S12LHH Service Manual ▷ View online
Service Manual 37
Disassembly
Disassembly
Indoor Unit
Warning :
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to “OFF”.
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to “OFF”.
To remove the Grille from the Chassis.
• Set the up-and-down air discharge louver to open
• Set the up-and-down air discharge louver to open
position (horizontally) by finger pressure.
• Remove the securing screws.
• To remove the Grille, pull the lower left and right
• To remove the Grille, pull the lower left and right
side of the grille toward you (slightly tilted) and lift it
straight upward.
straight upward.
1. Before removing the control box, be sure to
take out the wire screwed at the other end.
Display
P.C.B
Conductor
P.C.B
Conductor
Step Motor
Conductor
Conductor
Earth
Conductor
Conductor
Motor
Conductor
Conductor
Sensor
Conductor
Conductor
Earth
Conductor
Conductor
38 Room Air Conditioner
Disassembly
2. To remove the Control Box.
• Remove securing screws.
• Pull the control box out from the chassis
• Pull the control box out from the chassis
carefully.
3. To remove the Discharge Grille.
• Unhook the discharge grille and pull the
discharge grille out from the chassis carefully.
4. To remove the Evaporator.
• Remove 3 screws securing the evaporator(at the
left 2EA in the Eva Holder, at the right 1EA).
Caution label
CAUTION: When repair, do not damage
the Caution label.
the Caution label.
Service Manual 39
Disassembly
• Unhook the tab on the right inside of the chassis
at the same time, slightly pull the evaporator
toward you until the tab is clear of the slot.
toward you until the tab is clear of the slot.
5. To remove the Motor Cover
• Remove 2 securing screw.
• Pull the motor cover out from the chassis
• Pull the motor cover out from the chassis
carefully.
6. To remove the Cross-Flow Fan
• Loosen the screw securing the cross-flow fan to
the fan motor (do not remove).
• Lift up the right side of the cross-flow fan and the
fan motor, separate the fan motor from the
cross-flow fan.
cross-flow fan.
• Remove the left end of the cross-flow fan from
the self-aligning bearing.
Motor cover
40 Room Air Conditioner
7. To Remove the heater
• After removing the evaporator, remove screws
and terminals on the control box.
CAUTION:
• The high temperature on the heater's surface
can make injury.
• Be sure to check heater surface is not hot
before disassembilng!
Disassembly
Click on the first or last page to see other LS-H126RLN1 / LS-H096QLN1 / LS-H076QLN0 / S12LHH service manuals if exist.