JBL SPARK (serv.man5) EMC - CB Certificate ▷ View online
Report No.: EM201300221-5 Application No.: ZJ00028648 Page 45 of 68
FCC ID:
APISPARK
GFSK Highest Channel:
8DPSK Lowest Channel:
Report No.: EM201300221-5 Application No.: ZJ00028648 Page 46 of 68
FCC ID:
APISPARK
8DPSK Middle Channel:
8DPSK Highest Channel:
Report No.: EM201300221-5 Application No.: ZJ00028648 Page 47 of 68
FCC ID:
APISPARK
4.9 CONDUCTED SPURIOUS EMISSIONS
4.9.1 LIMITS
(d) In any 100 kHz bandwidth outside the frequency band in which the spread spectrum or digitally
modulated intentional radiator is operating. The radio frequency power that is produced by the
intentional radiator shall be at least 20 dB below that in the 100 kHz bandwidth within the band
that contains the highest level of the desired power. based on either an RF conducted or a radiated
measurement. Provided the transmitter demonstrates compliance with the peak conducted power
limits.
modulated intentional radiator is operating. The radio frequency power that is produced by the
intentional radiator shall be at least 20 dB below that in the 100 kHz bandwidth within the band
that contains the highest level of the desired power. based on either an RF conducted or a radiated
measurement. Provided the transmitter demonstrates compliance with the peak conducted power
limits.
4.9.2 TEST PROCEDURES
Remove the antenna from the EUT and then connect a low attenuation cable from the antenna port
to the spectrum.
Below 1GHz Set the spectrum analyzer: RBW =100KHz VBW >= RBW, Span = enough to catch
the trace. Sweep = auto; Detector Function = Peak. Trace = Max,hold.
Above 1GHz Set the spectrum analyzer: RBW =1MHz VBW >= RBW , Span = enough to catch
the trace. Sweep = auto; Detector Function = Peak. Trace = Max,hold.
to the spectrum.
Below 1GHz Set the spectrum analyzer: RBW =100KHz VBW >= RBW, Span = enough to catch
the trace. Sweep = auto; Detector Function = Peak. Trace = Max,hold.
Above 1GHz Set the spectrum analyzer: RBW =1MHz VBW >= RBW , Span = enough to catch
the trace. Sweep = auto; Detector Function = Peak. Trace = Max,hold.
4.9.3 TEST SETUP
4.9.4 TEST RESULTS
The unit does meet the FCC requirements.
Test result plot as follows:
EUT
Spectrum analyzer
Report No.: EM201300221-5 Application No.: ZJ00028648 Page 48 of 68
FCC ID:
APISPARK
For GFSK
Lowest Channel:
30M to 1GHz
1G to 10GHz
Click on the first or last page to see other SPARK (serv.man5) service manuals if exist.