Harman Kardon GO AND PLAY II (serv.man4) Service Manual ▷ View online
Harman Multimedia
HARMAN INTERNATIONAL COMPANY
NORTHRIDGE, CA 91329 USA
SIZE
TITLE
REV.
SHEET OF
SCALE:
B
DRAWING NO.
ENG
CHECKED
A
B
C
D
A
B
C
1
2
3
4
1
2
3
4
D
DATE
CAD FILE:
REVISION HISTORY
REV
ECO
CHECKED
DATE
PROPRIETARY INFORMATION - THESE DOCUMENTS AND THE INFORMATION
CONTAINED THEREIN ARE PROPRIETARY AND ARE NOT TO BE REPRODUCED
OR DISCLOSED TO OTHERS FOR MANUFACTURE OR ANY OTHER PURPOSE EXCEPT
THOSE SPECIFICALLY AUTHORIZED IN WRITTING BY HARMAN INTERNATIONAL
CONTAINED THEREIN ARE PROPRIETARY AND ARE NOT TO BE REPRODUCED
OR DISCLOSED TO OTHERS FOR MANUFACTURE OR ANY OTHER PURPOSE EXCEPT
THOSE SPECIFICALLY AUTHORIZED IN WRITTING BY HARMAN INTERNATIONAL
VOLUME DOWN
POWER SWITCH
1
3
2
4
5
SW1
ALPS SKHHPQA010
1
3
2
4
5
SW2
ALPS SKHHPQA010
1%
R2
100
1%
R1
75
1
2
3
4
5
2
3
4
5
J1
B 5B-ZR
2
1
D1A
LED DUAL
4
3
D1B
LED DUAL
GND
GO + PLAY II POWER CONTROL
070-0259
A
1
1
1) ALL RESISTORS 1/16 WATT 0603 PACKAGE. VALUE IN OHMS
NOTES: UNLESS OTHERWISE SPECIFIED
NOTES: UNLESS OTHERWISE SPECIFIED
2) ALL CAPACITORS 0603 PACKAGE.
SEE AGILE
POWER ON LED
BATT LOW LED
Disassembly procedure
1.
Use an angled tool.
2.
Gently loosen and withdraw the cable sleeve
that you now see.
3.
Gently pull the plastic cover
the same time carefully softening the glue with a
4.
Now you can exchange the iP
procedure for exchange of iPod connector PCB.
Gently loosen and withdraw the cable sleeves and cables, then insert the tool
cover (with dock connector and PCB) up and out of the unit,
softening the glue with a heat-gun/hair dryer.
iPod PCB.
1
, then insert the tool into the hole
up and out of the unit, while at
Disassembly procedure
1.
Use an angled tool.
2.
Gently loosen and withdraw the cable sleeve
that you now see.
3.
Gently pull the plastic cover
the same time carefully softening the glue with a
4.
Now you can exchange the iP
procedure for exchange of iPod connector PCB.
Gently loosen and withdraw the cable sleeves and cables, then insert the tool
cover (with dock connector and PCB) up and out of the unit,
softening the glue with a heat-gun/hair dryer.
iPod PCB.
1
, then insert the tool into the hole
up and out of the unit, while at
Disassembly procedure
1.
Use an angled tool.
2.
Gently loosen and withdraw the cable sleeve
that you now see.
3.
Gently pull the plastic cover
the same time carefully softening the glue with a
4.
Now you can exchange the iP
procedure for exchange of iPod connector PCB.
Gently loosen and withdraw the cable sleeves and cables, then insert the tool
cover (with dock connector and PCB) up and out of the unit,
softening the glue with a heat-gun/hair dryer.
iPod PCB.
1
, then insert the tool into the hole
up and out of the unit, while at