Harman Kardon AVR 7000 (serv.man7) User Manual / Operation Manual ▷ View online
SETUP CODES 49
Setup Code Tables: VCR
Manufacturer / Brand
Set-Up Code Number
JENSEN
043
JVC
002 043 044 048 159 166
KENWOOD
014 043 048
KRIESLER
053 167 187
KUBA
046
LLOYD
034
LOEWE OPTA
042 067 155 167 187
LOGIK
024 150
LUXOR
179 182
LXI
101
MAGNADYNE
039
MAGNASONIC
182
MAGNAVOX
107 109
MARANTZ
012 042 054 067 167 187
MATSUI
027 145 150
MEMOREX
003 010 014 034 053 101
METZ
042 046 167 174 181 187
MGA
059
MINERVA
162 174 187
MINOLTA
013 020
MITSUBISHI
047 048 059 148
MTC
034 040
MULTITECH
016 024 034
MURPHY
034
NAONIS
043 044 166
NATIONAL
183
NEC
012 031 043 048 166
NECKERMANN
006 039 042 043 166 187
NOBLIKO
187
NOGAMATIC
043 044 166
NOKIA
010 014 039 043 044 158 166 179 182
NORDMENDE
002 005 009 011 015 017 018 032 043 044
166 171 173 177 178
166 171 173 177 178
OPTONICA
053 054
ORION
006 026 027 028 060 145 150
OSAKI
034 101
OTTO VERSAND
046
P. CINEMA
042
PALLADIUM
039 042
PANASONIC
143 164 165 183
PATHE MARCONI
043 044 166
PENTAX
013 020
PERDIO
034
PHILIPS
037 041 042 045 053 054 067 152 155 167
187
187
PHONOLA
042 053 067 155 167 187
PIONEER
048 057
PORTLAND
108
PROLINE
034
PYE
042 053 067 155 167 187
QUARTZ
014
QUELLE
006 052 174 187
RADIOLA
053 167 187
RADIOMARELLI
039
RCA
107 109
REALISTIC
003 010 014 034 040 053 054
REX
043 044 166
Manufacturer / Brand
Set-Up Code Number
S. LORENZ
039
SABA
002 007 008 009 011 017 018 043 044 166
178
178
SAISHO
006 027 145 150 163
SALORA
014 059
SAMSUNG
040 102 104 107 109 113 115 168 172
SANSUI
043 048
SANYO
003 010 014 035 050 145 182
SBR
067 152 155
SCHAUB LORENZ
043 044 158 166 182
SCHNEIDER
024 034 053 167 172 187
SEG
172
SEI-SINUDYNE
150
SELECO
043 044 166
SENTRA
108
SHARP
053 054 105 147
SHINTOM
024
SIEMENS
042 046 162 167 174 182 187
SIERA
053 167 187
SINUDYNE
150
SONY
052 056 058 149 154
STERN
043 044 166
STS
013
SUNKAI
145
SYLVANIA
034 059
SYMPHONIC
034 059
TASHIKO
034
TATUNG
034 043
TEAC
034 043
TEKNIKA
034
TELEAVIA
043 044 166
TELEFUNKEN
002 011 019 021 033 043 044 166
TENOSAL
024
THOMSON
011 015 043 044 166
THORN-FERGUSON
017 018 043 157 159 166 170 176 180 184
TOSHIBA
004 043 044 049 059 153 166
TOTEVISION
040
UHER
043 172
ULTRAVOX
039
UNITECH
040
UNIVERSUM
039 042 046
URANYA
039
VECTOR 012
VICTOR
VICTOR
043 048
VIDITAL
039
WESTING HOUSE
039
WARDS
107 109
YAMAHA
012 043
ZANUSSI
043 044 166
ZENDER
166
ZOPPAS
043 044
50 TROUBLESHOOTING GUIDE
Troubleshooting Guide
Processor Reset
In the rare case where the unit’s operation or the
displays seem abnormal, the cause may involve
the erratic operation of the system’s memory or
microprocessor.
displays seem abnormal, the cause may involve
the erratic operation of the system’s memory or
microprocessor.
To correct this problem, first unplug the unit from
the AC wall outlet and wait at least three min-
utes. After the pause, reconnect the AC power
cord and check the unit’s operation. If the system
still malfunctions, a system reset may clear the
problem.
the AC wall outlet and wait at least three min-
utes. After the pause, reconnect the AC power
cord and check the unit’s operation. If the system
still malfunctions, a system reset may clear the
problem.
To clear the AVR 7000’s entire system memory
including tuner presets, output level settings,
delay times and speaker configuration data, first
put the unit in Standby by pressing the System
Power Control button 2. Next, press and hold
the Tone Mode 6 and the RDS @ buttons for
three seconds.
including tuner presets, output level settings,
delay times and speaker configuration data, first
put the unit in Standby by pressing the System
Power Control button 2. Next, press and hold
the Tone Mode 6 and the RDS @ buttons for
three seconds.
The unit will turn on automatically and display
the RESET message in the Main
Information Display W. Note that once you
have cleared the memory in this manner, it is nec-
essary to re-establish all system configuration
settings and tuner presets.
the RESET message in the Main
Information Display W. Note that once you
have cleared the memory in this manner, it is nec-
essary to re-establish all system configuration
settings and tuner presets.
NOTE: Resetting the processor will erase any
configuration settings you have made for speak-
ers, output levels, surround modes, digital input
assignments as well as the tuner presets. After a
reset the unit will be returned to the factory pre-
sets, and all settings for these items must be
reentered.
configuration settings you have made for speak-
ers, output levels, surround modes, digital input
assignments as well as the tuner presets. After a
reset the unit will be returned to the factory pre-
sets, and all settings for these items must be
reentered.
If the system is still operating incorrectly, there
may have been an electronic discharge or severe
AC line interference that has corrupted the mem-
ory or microprocessor.
may have been an electronic discharge or severe
AC line interference that has corrupted the mem-
ory or microprocessor.
If these steps do not solve the problem, consult
an authorized Harman Kardon service depot.
an authorized Harman Kardon service depot.
SYMPTOM
CAUSE
SOLUTION
Unit does not function when Main
• No AC Power
• Make certain AC power cord is plugged
Power Switch is pushed
into a live outlet
• Check to see if outlet is switch controlled
Display lights, but no sound
• Intermittent input connections
• Make certain that all input and speaker
or picture
connections are secure
• Mute is on
• Press Mute button
• Volume control is down
• Turn up volume control
Sound is heard, but Front-Panel
• Display brightness is turned off
• Follow the instructions in the Display Brightness section
Display does not light
on page 35 so that the display is set to VFD FULL
No sound from any speaker;
• Amplifier is in protection mode
• Check speaker-wire connections for shorts at receiver
light around power switch is red
due to possible short
and speaker ends
• Amplifier is in protection mode
• Contact your local Harman Kardon service depot
due to internal problems
No sound from surround or
• Incorrect surround mode
• Select a mode other than Stereo
center speakers
• Incorrect configuration
• Check speaker mode
• Stereo or Mono program material
• With (analog or digital) Dolby surround modes, the surround
decoder may not create rear-channel
information from nonencoded programs
information from nonencoded programs
• Speakers not properly connected
• Check speaker-wire connections or use test tone
to verify connections (see page 25)
Unit does not respond to
• Weak batteries in remote
• Change remote batteries
remote commands
• Wrong device selected
• Press the AVR selector
• Remote sensor is obscured
• Make certain front-panel sensor is visible to remote or
connect remote sensor
Intermittent buzzing in tuner
• Local interference
• Move unit or antenna away from computers, fluorescent lights,
motors or other electrical appliances
Letters flash in the Channel Indicator
• Digital audio feed paused
• Resume play for DVD
Display and Digital Audio stops
• Check that Digital Input is selected
HDCD encoded disc does not trigger
• Surround mode in use
• Select “Surround Off” mode
HDCD indicator
• Analog feed in use
• Connect and select digital connection to CD player
TECHNICAL SPECIFICATIONS 51
Technical Specifications
Audio Section
Stereo Mode Continuous Average Power (FTC)
Stereo Mode Continuous Average Power (FTC)
110 Watts per channel, 20Hz–20kHz,
@ < 0.07% THD, both channels driven into 8 ohms
@ < 0.07% THD, both channels driven into 8 ohms
Five-Channel Surround Modes
Power Per Individual Channel
Power Per Individual Channel
Front L&R channels:
100 Watts per channel,
@ < 0.07% THD, 20Hz–20kHz into 8 ohms
100 Watts per channel,
@ < 0.07% THD, 20Hz–20kHz into 8 ohms
Center channel:
100 Watts, @ < 0.07% THD, 20Hz–20kHz into 8 ohms
100 Watts, @ < 0.07% THD, 20Hz–20kHz into 8 ohms
Surround channels:
100 Watts per channel,
@ < 0.07% THD, 20Hz–20kHz into 8 ohms
100 Watts per channel,
@ < 0.07% THD, 20Hz–20kHz into 8 ohms
Input Sensitivity/Impedance
Linear (High Level)
200mV/47kohms
Signal-to-Noise Ratio (IHF-A)
95dB
Surround System Adjacent Channel Separation
Analog Decoding
40dB
(Pro Logic, etc.)
Dolby Digital (AC-3) 55dB
DTS
55dB
Frequency Response
@ 1W (+0dB, –3dB)
10Hz–100kHz
High Instantaneous
Current Capability (HCC)
Current Capability (HCC)
±75 Amps
Transient Intermodulation
Distortion (TIM)
Distortion (TIM)
Unmeasurable
Rise Time
16 µsec
Slew Rate
40V/µsec**
FM Tuner Section
Frequency Range
87.5–108MHz
Usable Sensitivity
IHF 1.3 µV/13.2dBf
Signal-to-Noise Ratio
Mono/Stereo: 70/65dB (DIN)
Distortion
Mono/Stereo: 0.15/0.3%
Stereo Separation
35dB @ 1kHz
Selectivity
±300kHz: 65dB
Image Rejection
80dB
IF Rejection
90dB
AM Tuner Section
Frequency Range
520–1611kHz
Signal-to-Noise Ratio
45dB
Usable Sensitivity
Loop: 500µV
Distortion
1kHz, 50% Mod: 0.8%
Selectivity
±9kHz: 30dB
Video Section
Video Format
PAL/NTSC
Input Level/Impedance
1Vp-p/75 ohms
Output Level/Impedance 1Vp-p/75 ohms
Video Frequency
Video Frequency
Response
10Hz–8MHz (–3dB)
General
Power Requirement
AC 220-240V/50Hz
Power Consumption
125W idle, 1100W maximum
Dimensions (Max)
Width
440mm
Height
193mm
Depth
519mm
Weight
22.3 kg
Depth measurement includes knobs, buttons and terminal connections.
Height measurement includes feet and chassis.
All features and specifications are subject to change without notice.
Height measurement includes feet and chassis.
All features and specifications are subject to change without notice.
Harman Kardon is a registered trademark, and Power for the digital revolution is a
trademark, of Harman International Industries, Inc.
trademark, of Harman International Industries, Inc.
*Manufactured under license from Dolby Laboratories.
“Dolby,” “Pro Logic,” “AC-3” and the Double-D symbol are
trademarks of Dolby Laboratories. Confidential Unpublished
Works. ©1992–1999 Dolby Laboratories, Inc. All rights reserved.
“Dolby,” “Pro Logic,” “AC-3” and the Double-D symbol are
trademarks of Dolby Laboratories. Confidential Unpublished
Works. ©1992–1999 Dolby Laboratories, Inc. All rights reserved.
†DTS and DTS Surround are trademarks of Digital Theater Systems, Inc.
††UltraStereo is a trademark of UltraStereo Corp.
††UltraStereo is a trademark of UltraStereo Corp.
VMAx is a trademark of Harman International Industries, Inc., and is an
implementation of Cooper Bauck Transaural Stereo under patent license.
implementation of Cooper Bauck Transaural Stereo under patent license.
Logic 7 is a registered trademark of Lexicon, Inc.
HDCD is a registered trademark of Pacific Microsonics.
Crystal is a registered trademark of Cirrus Logic Corp.
**Without input anti slewing and output isolation networks.
250 Crossways Park Drive, Woodbury, New York 11797
www.harmankardon.com
Harman Consumer International:
2, route de Tours, 72500 Château-du-Loir, France
© 1999 Harman Kardon, Incorporated
Part No.: J93000502000
www.harmankardon.com
Harman Consumer International:
2, route de Tours, 72500 Château-du-Loir, France
© 1999 Harman Kardon, Incorporated
Part No.: J93000502000