Sony GV-D1000E Service Manual ▷ View online
GV-D1000E
RMT-811
AEP Model
UK Model
SERVICE MANUAL
J200 MECHANISM
LEVEL
1
Revision History
Revision History
Ver 1.1 2003. 06
DIGITAL VIDEO CASSETTE RECORDER
• For INSTRUCTION MANUAL, refer to separate file (992992972.pdf).
Link
SERVICE NOTE
ORNAMENTAL PARTS
DISASSEMBLY
REPAIR PARTS LIST
SPECIFICATIONS
SERVICE NOTE
ORNAMENTAL PARTS
DISASSEMBLY
REPAIR PARTS LIST
SPECIFICATIONS
Link
— 2 —
GV-D1000E
AC power adaptor
Power requirements
100 - 240 V AC, 50/60 Hz
Output voltage
DC OUT: 8.4 V, 1.5 A in the
operating mode
Operating temperature
0
100 - 240 V AC, 50/60 Hz
Output voltage
DC OUT: 8.4 V, 1.5 A in the
operating mode
Operating temperature
0
°
C to 40
°
C (32
°
F to 104
°
F)
Storage temperature
–20
–20
°
C to +60
°
C (–4
°
F to +140
°
F)
Dimensions (approx.)
125
125
×
39
×
62 mm
(5
×
1 9/16
×
2 1/2 in.) (w/h/d)
excluding projecting parts
Mass (approx.)
280 g (9.8 oz)
excluding power cord
Mass (approx.)
280 g (9.8 oz)
excluding power cord
Design and specifications are
subject to change without notice.
subject to change without notice.
Audio output
Phono jacks (2) 327 mV, output
impedance less than 1 k
Phono jacks (2) 327 mV, output
impedance less than 1 k
Ω
(kilohms)
DV jack
4-pin connector: S100
Headphone jack
Stereo minijack (ø 3.5 mm)
LANC jack
Stereo minijack (ø 2.5 mm)
USB jack
Mini-B
DV jack
4-pin connector: S100
Headphone jack
Stereo minijack (ø 3.5 mm)
LANC jack
Stereo minijack (ø 2.5 mm)
USB jack
Mini-B
LCD screen
Picture
10 cm (4.0 type)
80.6
10 cm (4.0 type)
80.6
×
60.5 mm (3 1/4
×
2 1/2 in.)
Total dot number
123 200 (560
123 200 (560
×
220)
General
Power requirements
8.4 V (AC power adaptor)
7.2 V (battery pack)
Average power consumption
During playback using LCD
5.2 W
During playback when you close
the LCD panel
3.5 W
Operating temperature
0
8.4 V (AC power adaptor)
7.2 V (battery pack)
Average power consumption
During playback using LCD
5.2 W
During playback when you close
the LCD panel
3.5 W
Operating temperature
0
°
C to 40
°
C (32
°
F to 104
°
F)
Storage temperature
–20
–20
°
C to +60
°
C (–4
°
F to +140
°
F)
Dimensions (Approx.)
148
148
×
65
×
133 mm
(5 7/8
×
2 5/8
×
5 1/8 in.)
(w/h/d)
Mass (approx.)
880 g (1 lb 15 oz)
excluding the battery pack and
cassette
Supplied accessories
See page 3.
Mass (approx.)
880 g (1 lb 15 oz)
excluding the battery pack and
cassette
Supplied accessories
See page 3.
VCR
System
Video recording system
2 rotary heads
Helical scanning system
Audio recording system
Rotary heads, PCM system
Quantization: 12 bits (Fs 32 kHz,
stereo 1, stereo 2),
16 bits (Fs 48 kHz, stereo)
Video signal
PAL colour, CCIR standards
Usable cassette
Mini DV cassette with the
mark printed
Tape speed
SP: Approx. 18.81 mm/s
LP: Approx. 12.56 mm/s
Recording/playback time (using
cassette DVM60)
SP: 1 hour
LP: 1.5 hours
Fastforward/rewind time (using
cassette DVM60)
Approx. 2 min.
2 rotary heads
Helical scanning system
Audio recording system
Rotary heads, PCM system
Quantization: 12 bits (Fs 32 kHz,
stereo 1, stereo 2),
16 bits (Fs 48 kHz, stereo)
Video signal
PAL colour, CCIR standards
Usable cassette
Mini DV cassette with the
mark printed
Tape speed
SP: Approx. 18.81 mm/s
LP: Approx. 12.56 mm/s
Recording/playback time (using
cassette DVM60)
SP: 1 hour
LP: 1.5 hours
Fastforward/rewind time (using
cassette DVM60)
Approx. 2 min.
Input/output
connectors
connectors
S video input
4-pin mini DIN
Luminance signal: 1 Vp-p, 75
4-pin mini DIN
Luminance signal: 1 Vp-p, 75
Ω
(ohms), unbalanced
Chrominance signal: 0.3 Vp-p,
75
Chrominance signal: 0.3 Vp-p,
75
Ω
(ohms), unbalanced
S video output
4-pin mini DIN
Luminance signal: 1 Vp-p, 75
4-pin mini DIN
Luminance signal: 1 Vp-p, 75
Ω
(ohms), unbalanced
Chrominance signal: 0.3 Vp-p,
75
Chrominance signal: 0.3 Vp-p,
75
Ω
(ohms), unbalanced
Audio/Video input
AV MINIJACK
Video: 1 Vp-p, 75
AV MINIJACK
Video: 1 Vp-p, 75
Ω
(ohms),
unbalanced, sync negative
Audio: 327 mV, input impedance
more than 47 k
Audio: 327 mV, input impedance
more than 47 k
Ω
(kilohms)
Video output
Phono jack, 1 Vp-p, 75
Phono jack, 1 Vp-p, 75
Ω
(ohms),
unbalanced, sync negative
SPECIFICATIONS
COVER
COVER
— 3 —
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED LINE WITH
MARK
0
ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
1.
Check the area of your repair for unsoldered or poorly-soldered
connections. Check the entire board surface for solder splashes
and bridges.
connections. Check the entire board surface for solder splashes
and bridges.
2.
Check the interboard wiring to ensure that no wires are
"pinched" or contact high-wattage resistors.
"pinched" or contact high-wattage resistors.
3.
Look for unauthorized replacement parts, particularly
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
4.
Look for parts which, through functioning, show obvious signs
of deterioration. Point them out to the customer and
recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
5.
Check the B+ voltage to see it is at the values specified.
6.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
GV-D1000E
CAUTION :
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Checking supplied accessories.
Make sure that the following accessories are supplied with your camcorder.
Other accessories
3-071-571-11 MANUAL, INSTRUCTION (ENGLISH/RUSSIAN)
3-071-571-21 MANUAL, INSTRUCTION (FRENCH/SPANISH) (AEP)
3-071-571-31 MANUAL, INSTRUCTION (GERMAN/DUTCH) (AEP)
3-071-571-41 MANUAL, INSTRUCTION (ITALIAN/PORTUGUESE) (AEP)
3-071-571-21 MANUAL, INSTRUCTION (FRENCH/SPANISH) (AEP)
3-071-571-31 MANUAL, INSTRUCTION (GERMAN/DUTCH) (AEP)
3-071-571-41 MANUAL, INSTRUCTION (ITALIAN/PORTUGUESE) (AEP)
Note :
The components identified by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specified.
AC power adaptor (1)
(AC-L10A)
(AC-L10A)
0
1-475-599-11
CD-ROM
(SPVD-008
USB Driver)(1)
3-072-414-01
(SPVD-008
USB Driver)(1)
3-072-414-01
A/V converting cable (17cm) (1)
1-824-009-71
1-824-009-71
21-pin adaptor (1)
1-573-291-11
1-573-291-11
A/V connecting cable
(1.5m) (1)
1-757-334-11
(1.5m) (1)
1-757-334-11
Power cord (Mains lead)(1) (AEP model)
0
1-769-608-11
Power cord (Mains lead)(1) (UK model)
0
1-783-374-11
USB cable (1)
1-757-293-11
1-757-293-11
Wireless Remote Commander (1)
RMT-811
1-475-950-21
Lid, Battery Case (for RMT-811)
3-053-056-01
RMT-811
1-475-950-21
Lid, Battery Case (for RMT-811)
3-053-056-01
Size R6 (AA) battery for
Remote Commander (2)
(not supplied)
Remote Commander (2)
(not supplied)
Ver 1.1 2003. 06
— 4 —
GV-D1000E
TABLE OF CONTENTS
SERVICE NOTE
1.
POWER SUPPLY DURING REPAIRS ····························· 5
2.
TO TAKE OUT A CASSETTE WHEN NOT EJECT
(FORCE EJECT) ································································ 5
(FORCE EJECT) ································································ 5
SELF-DIAGNOSIS FUNCTION
1.
SELF-DIAGNOSIS FUNCTION ······································· 6
2.
SELF-DIAGNOSIS DISPLAY ·········································· 6
3.
SERVICE MODE DISPLAY ············································· 6
3-1.
Display Method ·································································· 6
3-2.
Switching of Backup No. ··················································· 6
3-3.
End of Display ···································································· 6
4.
SELF-DIAGNOSIS CODE TABLE ··································· 7
1.
MAIN PARTS
1.
ORNAMENTAL PARTS ···················································· 8
2.
DISASSEMBLY ································································· 9
2-1.
LCD CABINET ASSEMBLY ·········································· 10
2-2.
PD-130 BOARD, LS-56 BOARD ···································· 10
2-3.
LCD WINDOW CABINET ASSEMBLY
(LCD901, ND901, SP901, SP902) ··································· 11
(LCD901, ND901, SP901, SP902) ··································· 11
2-4.
BOTTOM CABINET ASSEMBLY, FP-571 FLEXIBLE
BOARD (V/L RECHARGEABLE BATTERY) ·············· 12
BOARD (V/L RECHARGEABLE BATTERY) ·············· 12
2-5.
VC-275 BOARD ······························································ 12
2-6.
BATTERY TERMINAL BOARD ···································· 13
2-7.
FP-575 FLEXIBLE BOARD (LANC), PR-41 BOARD,
IO-69 BOARD ·································································· 13
IO-69 BOARD ·································································· 13
2-8.
MS-95 BOARD ································································ 14
2-9.
MECHANISM DECK ······················································ 14
2-10. EJ-35 BOARD ·································································· 15
2-11. EX-39 BOARD ································································ 16
2-12. MEMORY STICK CONNECTOR (10P),
2-11. EX-39 BOARD ································································ 16
2-12. MEMORY STICK CONNECTOR (10P),
FK-81 BOARD ································································· 17
2-13. FP-602 FLEXIBLE BOARD (DV IN/OUT),
LCD BLOCK ASSEMBLY ·············································· 18
2-14. HINGE UNIT, FP-569 FLEXIBLE BOARD ··················· 19
3.
3.
REPAIR PARTS LIST ······················································ 20
3-1.
EXPLODED VIEWS ······················································· 20
3-1-1. OVERALL SECTION ······················································ 20
3-1-2. CABINET (UPPER) SECTION-1 ··································· 21
3-1-3. CABINET (UPPER) SECTION-2 ··································· 22
3-1-4. LCD SECTION ································································ 23
3-1-2. CABINET (UPPER) SECTION-1 ··································· 21
3-1-3. CABINET (UPPER) SECTION-2 ··································· 22
3-1-4. LCD SECTION ································································ 23