DOWNLOAD Sony XBR-55HX955 / XBR-65HX955 Service Manual ↓ Size: 6.72 MB | Pages: 54 in PDF or view online for FREE

XBR-55HX955/65HX955 vi

After correcting the original service problem, perform the following safety 

checks before releasing the set to the customer:

1.  Check the area of your repair for unsoldered or poorly soldered 

connections. Check the entire board surface for solder splashes 

and bridges.

2.  Check the interboard wiring to ensure that no wires are “pinched” 

or touching high-wattage resistors.

3.  Check that all control knobs, shields, covers, ground straps and 

mounting hardware have been replaced. Be absolutely certain 

that you have replaced all the insulators.

4.  Look for unauthorized replacement parts, particularly transistors, 

that were installed during a previous repair. Point them out to the 

customer and recommend their replacement.

5.  Look for parts which, though functioning, show obvious signs of 

deterioration. Point them out to the customer and recommend 

their replacement.

6.  Check the line cords for cracks and abrasion. Recommend the 

replacement of any such line cord to the customer.

7.  Check the antenna terminals, metal trim, “metallized” knobs, 

screws and all other exposed metal parts for AC leakage. Check 

leakage as described in “Leakage Test”.

The AC leakage from any exposed metal part to earth ground and from all 

exposed metal parts to any exposed metal part having a return to chassis, 

must not exceed 0.5 mA (500 microamperes). Leakage current can be 

measured by any one of three methods.

1.  A commercial leakage tester.  

Follow the manufacturers’ instructions provided with the tester.

2.  A battery-operated AC milliammeter. 

3.  Measuring the voltage drop across a resistor by means of a VOM 

or battery-operated AC voltmeter. The “limit” indication is 0.75 V, so 

analog meters must have an accurate low voltage scale. Nearly all 

battery-operated digital multimeters that have a 2 VAC range are 

suitable. (see Figure A)

Figure A. Use an AC voltmeter to check AC leakage.

The cover-plate retaining screw on most AC outlet boxes is at earth ground. 

Verify the AC outlet box retaining screw ground by connecting a 60W to 

100W incandescent (not a neon or fluorescent lamp) between the hot side of 

the receptacle and the retaining screw. Try both slots, if necessary, to locate 

the hot side on the line; the lamp should light at normal brilliance if the screw 

is at ground potential. (see Figure B)

Figure B. Checking for earth ground.

Trouble Light

AC Outlet Box

XBR-55HX955/65HX955 1

The AZ3F chassis is one of several designs for the 2012 model line of Sony 

Bravia® LCD televisions. This manual covers the following models:
 KDL-55HX955
 KDL-65HX955

The BRAVIA® HX95x series features a truly transcendent picture quality, 

each scene in everything you watch - HD movies, 3D, sports, even 

YouTube™ clips - is presented with unprecedented detail and astonishing 

color from Sony’s exclusive X-Reality™ PRO picture engine. Ultra-clear, 

realistic motion during slow scenic sweeps and fast action sports comes 

courtesy of Motionflow™ XR 960.

 

Pro-grade detail for discerning eyes: X-Reality™ PRO

 

Experience precise motion clarity with Motionflow™ XR 960

 

Frameless design with Corning’s Gorilla® Glass

 

Movies, music & apps with Sony Entertainment Network

1

 

Amazingly crisp, natural 3D effects in every 3D scene

2

 

Dynamic Edge LED backlight for amazing contrast & color

 

Stream HD entertainment wirelessly with built-in Wi-Fi®

1

 

PC and tablet content

3

 on your TV with Intelligent Connect

 

Make life-sized video calls with Skype®

1

 

Media Remote™ app to control your TV with a smartphone

4

 

Connect to the TV via Wi-Fi® without using a router

3

Sistema de TV

Análogo: NTSC 3.58 
Digital: DVB-T2T 

Cobertura de canales

CATV (Análogo): 1-135

Sistema del panel
Salida de bocinas

CABLE/ANTENNA 

(Cable/Antena)

Terminal externa de 75 ohms para entrada de señal de radiofrecuencia

VIDEO IN 1

(Entrada de video 1)

Entrada de video/audio (izquierda-derecha)

COMPONENT IN

(Entrada de componente)

VIDEO IN 2

(Entrada de video 2)

YP

B

P

R

 (video componente): 1080p (60 Hz), 1080i (60 Hz), 720p (60 Hz),  480p, 480i

Entrada de audio (izquierda-derecha)
Entrada de video (contacto común de componente)

HDMI IN 1/2/3/4

Video (2D): 1080p (30, 60 Hz), 1080/24p, 1080i (60 Hz), 720p (30, 60 Hz),  

720/24p, 480p, 480i, Formatos de PC

Video (3D):

Estructuración de imágenes: 1080p (30 Hz), 1080/24p, 1080i (60 Hz), 

720p (30, 60 Hz), 720/24p

Una a lado de otra: 1080p (60 Hz), 1080/24p, 1080i (60 Hz), 720p (60 Hz) 
Una arriba de otra: 1080p (30, 60 Hz), 1080/24p, 1080i (60 Hz), 720p (60 Hz) 
Audio: PCM lineal de dos canales: 32; 44,1 y 48 kHz, 16, 20 y 24 bits, Dolby Digital 
Entrada de audio analógico (minitoma estéreo) sólo HDMI IN 2, común con PC IN 
ARC (sólo HDMI IN 1)

AUDIO OUT 

(Salida de audio)/Auriculares

Minitoma estéreo

DIGITAL AUDIO OUT 

PC IN (Entrada de PC)

PC/HDMI 2 AUDIO IN 

(Entrada de audio de PC/HDMI 2)

RGB analógico (Conector D-sub de 15 pines)
Entrada de audio (minitoma estéreo) (común con HDMI IN 2)

Conector 10BASE-T/100BASE-TX (La velocidad de la conexión podría variar en función del

N

A

L

entorno de red. No se garantizan la tasa de comunicación ni la calidad de comunicación 

 10BASE-T/100BASE-TX para este TV)

Consulte el i-Manual para el formato compatible

USB/DLNA

VHF: 2-13, UHF: 14-69

Panel LCD (pantalla de cristal líquido)
10 W + 10 W + 10 W

Toma óptica digital (PCM lineal de dos canales, Dolby Digital)

(OPTICAL)

1.  Broadband speed of at least 2.5 Mbps recommended (10 Mbps for HD). Content subject to 

change and may require fees. Skype requires CMU-BR100 camera sold separately. Subject 

to Skype’s terms and conditions. 

2.  Requires 3D content, 3D player, HDMI® cable (at least 10.2 Gbps) and 3D active glasses 

sold separately. 

3.  Streaming content, copy-protected content and certain formats are not supported. 
4.  Requires devices connected to the same wireless home network.

XBR-55HX955/65HX955 2

* El tamaño, las dimensiones y el peso de la pantalla son valores aproximados.

•

La disponibilidad de los accesorios opcionales dependerá de los países, regiones, modelo del TV 

y de las existencias.

•

El diseño y las especificaciones están sujetos a cambios sin previo aviso.

Requisitos de alimentación
Consumo de 

potencia

en uso

 

Menos de 0,35 W

en espera

Tamaño de pantalla*

(medido diagonalmente) 

163,9

64,5

(65 clase)

138,8

54,6

(55 clase)

Resolución del monitor 

 

(horizontal) × 1080 líneas (vertical)

Dimensiones*   con soporte

sin soporte
patrón de 

orificios de 

montaje mural

(mm)

400 x 300

tamaño de 
tornillos de 
montaje mural 

(mm)

M6 (8-12 mm)

con soporte
sin soporte

Accesorios opcionales

Gafas 3D: TDG-BR750/TDG-BR250/TDG-BR200/TDG-BR100/TDG-BR50

Unidad de cámara y micrófono: CMU-BR100

Adaptador de LAN inalámbrica USB: UWA-BR100

Temperatura de funcionamiento

110-240 V ca, 50/60 Hz 

190 W 

252 W 

(pulgadas)

(cm)

1920 puntos

1280 x 829 x 369

1506 x 965 x 374

(mm)

1280 x 773 x 49

1506 x 901 x 51

 (mm)

300 × 300

29,6

47,7

(kg)

26,7

43,6

(kg)

Peso*

Soporte de montaje mural: SU-WL500

0 ºC – 40 ºC

(excepto XBR-65HX955)
Tornillos de fijación para el soporte   

de sobremesa (M5 × 16) (3) 
(excepto XBR-65HX955)
Tornillos de montaje para el soporte  
de sobremesa (M5 x 16) (4) 

(excepto XBR-65HX955)
Manual de instrucciones y otros

*

1

Consulte el número del modelo impreso en el  

control remoto.

*

2

Se requiere ensamblar la base de soporte de 

sobremesa. Para ensamblar la base de soporte 

de sobremesa consulte el folleto suministrado.

XBR-55HX955/65HX955 3

The primary circuits in the AZ3F chassis consist of a Main Board (BAPS Board), Power Supply Board (G6D/G13 Boards for the 55” models and G14/G15 

Boards for the 65” models), the IR Board (HL Board), the 3D IR Emitter (HEM3 Board), the Wireless LAN Card, the Switch Unit, and the LCD Panel Assembly 

which includes the TCON Board and LD Board.
NOTE: For Connector part number information, refer to 

. For Wire Dressing information, refer to 

.

TCON

SWITCH

UNIT

HL

HEM3

G13

G6D

BAPS

WIRELESS

LAN CARD

TCON

LD

SWITCH

UNIT

HL

HEM3

G15

G14

BAPS

WIRELESS

LAN CARD

TCON

LD