Sony KLV-52V410A / KLV-52W410A (serv.man2) Service Manual ▷ View online
KLV-52V410A/52W410A
KLV-52V410A/52W410A
77
Sony Corporation
Sony Technology Center
Technical Services
Service Promotion Department
9-883-798-02
English
2008HJ74WEB-1
Printed in USA
© 2008.08
REF. NO.
PART NO.
DESCRIPTION
VALUES
REF. NO.
PART NO.
DESCRIPTION
VALUES
R312 1-218-971-11 RES-CHIP
33K 5% 1/16W
R314 1-218-953-11 RES-CHIP
1K 5% 1/16W
H4
A-1494-139-A
H4
BOARD,
MOUNTED
CAPACITOR
C401 1-112-068-11 CERAMIC
CHIP
220pF 10%
50V
C402 1-100-909-11 CERAMIC
CHIP
10μF 10%
6.3V
IC
IC401 6-600-681-01 IC
RS-770N
RESISTOR
R401 1-218-949-11 RES-CHIP
470 5% 1/16W
R402 1-218-937-11 RES-CHIP
47
5% 1/16W
H4
NOTE: The components identifi ed by shading
and
and
!
mark are critical for safety. Replace only
with part number specifi ed.
ACCESSORIES AND PACKING
*
4-000-406-01
CARTON, INDIVIDUAL
(KLV-52V410A
ONLY)
*
4-000-403-01
CARTON, INDIVIDUAL
(KLV-52W410A
ONLY)
*
3-876-193-01
CUSHION, LOWER
*
3-876-192-01
CUSHION, UPPER
3-299-074-11 FLYER,
LINUX
3-299-071-11 FLYER,
SAFETY
3-452-150-31
GUIDE, QUICK SETUP
3-452-149-32
MANUAL, INSTRUCTION
!
1-835-546-11
POWER-SUPPLY CORD
*
3-879-887-11
SHEET, PROTECTION
*
3-879-887-21
SHEET, PROTECTION
A-1552-258-A STAND
(SVC)
ASSY
(KLV-52W410A
ONLY)
*
3-876-042-01
TRAY
MISCELLANEOUS
4-106-726-01 LOCK,
PUSH
2-580-644-01 SCREW,
+KTP2
3X8
2-580-608-01 SCREW,
+PSW
M5X16
(SCREWS TO ATTACH TABLE-TOP STAND TO TV)
For product protection and safety reasons, Sony strongly recommends that
you use the screws provided with the TV.
2-650-770-11 SLIDE,
CLAMP
X-2186-602-1 SUPPORT
BELT
KIT
2-688-062-01 TAPE
(LCD)
7-632-452-24
TAPE (NO. 303) 18MMX35M YEL
2-888-494-01 TAPE,
EARTH
(KLV-52V410A
ONLY)
REMOTE COMMANDER
1-480-617-12
REMOTE COMMANDER (RM-YD023)
9-885-117-43
BATTERY COVER (RM-YD023)
H3E
A-1
KLV-52V410A/52W410A
KLV-52V410A/52W410A
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential
information, and shall be handled under the non-disclosure obligations provided in the
applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit
Board containing encryption key components is repaired and/or replaced pursuant to the
following:
1) In the service manual the Circuit Board(s) containing encryption key components
1) In the service manual the Circuit Board(s) containing encryption key components
shall be identified with a red outline and a .
2) Only repair boards or components listed in the service manual shall be utilized for
replacement and/or repair.
3) Disassembly, decryption, or reverse-engineering component(s) is strictly prohibited.
4) Any board in which the Servicer replaces an encryption key component must be
4) Any board in which the Servicer replaces an encryption key component must be
placed back into the set it orignally came from and the replaced defective component
MUST BE DESTROYED. Boards cannot be swapped.
5) If a Circuit Board identified with a red outline and a in the service manual is deemed
to be defective:
a) and if a core charge is imposed and is covered under the product warranty, the
defective un-repaired or modified board MUST BE RETURNED to Sony.
b) and if the core charge is NOT covered under the product warranty, the defective
un-repaired or modified board MUST BE DESTROYED.
5) If a unit is destroyed (such as field scrap), the Circuit Board identified with a
red outline and a in the service manual MUST BE DESTROYED.
A-1
KLV-52V410A/52W410A
KLV-52V410A/52W410A
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential
information, and shall be handled under the non-disclosure obligations provided in the
applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit
Board containing encryption key components is repaired and/or replaced pursuant to the
following:
1) In the service manual the Circuit Board(s) containing encryption key components
1) In the service manual the Circuit Board(s) containing encryption key components
shall be identified with a red outline and a .
2) Only repair boards or components listed in the service manual shall be utilized for
replacement and/or repair.
3) Disassembly, decryption, or reverse-engineering component(s) is strictly prohibited.
4) Any board in which the Servicer replaces an encryption key component must be
4) Any board in which the Servicer replaces an encryption key component must be
placed back into the set it orignally came from and the replaced defective component
MUST BE DESTROYED. Boards cannot be swapped.
5) If a Circuit Board identified with a red outline and a in the service manual is deemed
to be defective:
a) and if a core charge is imposed and is covered under the product warranty, the
defective un-repaired or modified board MUST BE RETURNED to Sony.
b) and if the core charge is NOT covered under the product warranty, the defective
un-repaired or modified board MUST BE DESTROYED.
5) If a unit is destroyed (such as field scrap), the Circuit Board identified with a
red outline and a in the service manual MUST BE DESTROYED.
A-1
KLV-52V410A/52W410A
KLV-52V410A/52W410A
APPENDIX A: ENCRYPTION KEY COMPONENTS
Encryption key components developed by Sony Corporation contain confidential
information, and shall be handled under the non-disclosure obligations provided in the
applicable agreement with Sony Corporation (and/or its subsidiary).
As part of this agreement specific instructions must be adhered to whenever a Circuit
Board containing encryption key components is repaired and/or replaced pursuant to the
following:
1) In the service manual the Circuit Board(s) containing encryption key components
1) In the service manual the Circuit Board(s) containing encryption key components
shall be identified with a red outline and a .
2) Only repair boards or components listed in the service manual shall be utilized for
replacement and/or repair.
3) Disassembly, decryption, or reverse-engineering component(s) is strictly prohibited.
4) Any board in which the Servicer replaces an encryption key component must be
4) Any board in which the Servicer replaces an encryption key component must be
placed back into the set it orignally came from and the replaced defective component
MUST BE DESTROYED. Boards cannot be swapped.
5) If a Circuit Board identified with a red outline and a in the service manual is deemed
to be defective:
a) and if a core charge is imposed and is covered under the product warranty, the
defective un-repaired or modified board MUST BE RETURNED to Sony.
b) and if the core charge is NOT covered under the product warranty, the defective
un-repaired or modified board MUST BE DESTROYED.
5) If a unit is destroyed (such as field scrap), the Circuit Board identified with a
red outline and a in the service manual MUST BE DESTROYED.